ARCv2: PAE40: Explicitly set MSB counterpart of SLC region ops addresses

commit 7d79cee2 upstream.

It is necessary to explicitly set both SLC_AUX_RGN_START1 and SLC_AUX_RGN_END1
which hold MSB bits of the physical address correspondingly of region start
and end otherwise SLC region operation is executed in unpredictable manner

Without this patch, SLC flushes on HSDK (IOC disabled) were taking
seconds.
Reported-by: Vladimir Kondratiev <vladimir.kondratiev@intel.com>
Signed-off-by: Alexey Brodkin <abrodkin@synopsys.com>
Signed-off-by: Vineet Gupta <vgupta@synopsys.com>
[vgupta: PAR40 regs only written if PAE40 exist]
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

arch/arc/include/asm/cache.h

@@ -88,7 +88,9 @@ extern int ioc_exists;
 #define ARC_REG_SLC_FLUSH	0x904
 #define ARC_REG_SLC_INVALIDATE	0x905
 #define ARC_REG_SLC_RGN_START	0x914
+#define ARC_REG_SLC_RGN_START1	0x915
 #define ARC_REG_SLC_RGN_END	0x916
+#define ARC_REG_SLC_RGN_END1	0x917
 
 /* Bit val in SLC_CONTROL */
 #define SLC_CTRL_IM		0x040

arch/arc/mm/cache.c

@@ -543,6 +543,7 @@ noinline void slc_op(phys_addr_t paddr, unsigned long sz, const int op)
 	static DEFINE_SPINLOCK(lock);
 	unsigned long flags;
 	unsigned int ctrl;
+	phys_addr_t end;
 
 	spin_lock_irqsave(&lock, flags);
 
@@ -572,8 +573,16 @@ noinline void slc_op(phys_addr_t paddr, unsigned long sz, const int op)
 	 * END needs to be setup before START (latter triggers the operation)
 	 * END can't be same as START, so add (l2_line_sz - 1) to sz
 	 */
-	write_aux_reg(ARC_REG_SLC_RGN_END, (paddr + sz + l2_line_sz - 1));
-	write_aux_reg(ARC_REG_SLC_RGN_START, paddr);
+	end = paddr + sz + l2_line_sz - 1;
+	if (is_pae40_enabled())
+		write_aux_reg(ARC_REG_SLC_RGN_END1, upper_32_bits(end));
+
+	write_aux_reg(ARC_REG_SLC_RGN_END, lower_32_bits(end));
+
+	if (is_pae40_enabled())
+		write_aux_reg(ARC_REG_SLC_RGN_START1, upper_32_bits(paddr));
+
+	write_aux_reg(ARC_REG_SLC_RGN_START, lower_32_bits(paddr));
 
 	while (read_aux_reg(ARC_REG_SLC_CTRL) & SLC_CTRL_BUSY);