drm/msm/dpu: rename enable_compression() to program_intf_cmd_cfg()

Rename the intf's enable_compression() op to program_intf_cmd_cfg()
and allow it to accept a struct intf_cmd_mode_cfg to program
all the bits at once. This can be re-used by widebus later on as
well as it touches the same register.

changes in v5:
	- rename struct intf_cmd_mode_cfg to dpu_hw_intf_cmd_mode_cfg
	- remove couple of comments
Signed-off-by: Abhinav Kumar <quic_abhinavk@quicinc.com>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Patchwork: https://patchwork.freedesktop.org/patch/546806/
Link: https://lore.kernel.org/r/20230712012003.2212-5-quic_abhinavk@quicinc.comSigned-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>

drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c

@@ -50,6 +50,7 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg(
 			to_dpu_encoder_phys_cmd(phys_enc);
 	struct dpu_hw_ctl *ctl;
 	struct dpu_hw_intf_cfg intf_cfg = { 0 };
+	struct dpu_hw_intf_cmd_mode_cfg cmd_mode_cfg = {};
 
 	ctl = phys_enc->hw_ctl;
 	if (!ctl->ops.setup_intf_cfg)
@@ -68,8 +69,11 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg(
 				phys_enc->hw_intf,
 				phys_enc->hw_pp->idx);
 
-	if (intf_cfg.dsc != 0 && phys_enc->hw_intf->ops.enable_compression)
-		phys_enc->hw_intf->ops.enable_compression(phys_enc->hw_intf);
+	if (intf_cfg.dsc != 0)
+		cmd_mode_cfg.data_compress = true;
+
+	if (phys_enc->hw_intf->ops.program_intf_cmd_cfg)
+		phys_enc->hw_intf->ops.program_intf_cmd_cfg(phys_enc->hw_intf, &cmd_mode_cfg);
 }
 
 static void dpu_encoder_phys_cmd_pp_tx_done_irq(void *arg, int irq_idx)

drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c

@@ -513,10 +513,12 @@ static void dpu_hw_intf_disable_autorefresh(struct dpu_hw_intf *intf,
 
 }
 
-static void dpu_hw_intf_enable_compression(struct dpu_hw_intf *ctx)
+static void dpu_hw_intf_program_intf_cmd_cfg(struct dpu_hw_intf *ctx,
+					     struct dpu_hw_intf_cmd_mode_cfg *cmd_mode_cfg)
 {
 	u32 intf_cfg2 = DPU_REG_READ(&ctx->hw, INTF_CONFIG2);
 
+	if (cmd_mode_cfg->data_compress)
 		intf_cfg2 |= INTF_CFG2_DCE_DATA_COMPRESS;
 
 	DPU_REG_WRITE(&ctx->hw, INTF_CONFIG2, intf_cfg2);
@@ -544,7 +546,7 @@ static void _setup_intf_ops(struct dpu_hw_intf_ops *ops,
 	}
 
 	if (mdss_rev->core_major_ver >= 7)
-		ops->enable_compression = dpu_hw_intf_enable_compression;
+		ops->program_intf_cmd_cfg = dpu_hw_intf_program_intf_cmd_cfg;
 }
 
 struct dpu_hw_intf *dpu_hw_intf_init(const struct dpu_intf_cfg *cfg,

drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h

@@ -48,6 +48,10 @@ struct dpu_hw_intf_status {
 	u32 line_count;		/* current line count including blanking */
 };
 
+struct dpu_hw_intf_cmd_mode_cfg {
+	u8 data_compress;	/* enable data compress between dpu and dsi */
+};
+
 /**
  * struct dpu_hw_intf_ops : Interface to the interface Hw driver functions
  *  Assumption is these functions will be called after clocks are enabled
@@ -70,7 +74,7 @@ struct dpu_hw_intf_status {
  * @get_autorefresh:            Retrieve autorefresh config from hardware
  *                              Return: 0 on success, -ETIMEDOUT on timeout
  * @vsync_sel:                  Select vsync signal for tear-effect configuration
- * @enable_compression:         Enable data compression
+ * @program_intf_cmd_cfg:       Program the DPU to interface datapath for command mode
  */
 struct dpu_hw_intf_ops {
 	void (*setup_timing_gen)(struct dpu_hw_intf *intf,
@@ -108,7 +112,8 @@ struct dpu_hw_intf_ops {
 	 */
 	void (*disable_autorefresh)(struct dpu_hw_intf *intf, uint32_t encoder_id, u16 vdisplay);
 
-	void (*enable_compression)(struct dpu_hw_intf *intf);
+	void (*program_intf_cmd_cfg)(struct dpu_hw_intf *intf,
+				     struct dpu_hw_intf_cmd_mode_cfg *cmd_mode_cfg);
 };
 
 struct dpu_hw_intf {