net: phy: remove unnecessary line continuation

Avoid unnecessary line continuations, and put '|' at the end of line.
Signed-off-by: Wenpeng Liang <liangwenpeng@huawei.com>
Signed-off-by: Weihang Li <liweihang@huawei.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/dp83640.c

@@ -170,9 +170,9 @@ static ushort gpio_tab[GPIO_TABLE_SIZE] = {
 module_param(chosen_phy, int, 0444);
 module_param_array(gpio_tab, ushort, NULL, 0444);
 
-MODULE_PARM_DESC(chosen_phy, \
+MODULE_PARM_DESC(chosen_phy,
 	"The address of the PHY to use for the ancillary clock features");
-MODULE_PARM_DESC(gpio_tab, \
+MODULE_PARM_DESC(gpio_tab,
 	"Which GPIO line to use for which purpose: cal,perout,extts1,...,extts6");
 
 static void dp83640_gpio_defaults(struct ptp_pin_desc *pd)

drivers/net/phy/et1011c.c

@@ -73,10 +73,10 @@ static int et1011c_read_status(struct phy_device *phydev)
 					ET1011C_GIGABIT_SPEED) {
 			val = phy_read(phydev, ET1011C_CONFIG_REG);
 			val &= ~ET1011C_TX_FIFO_MASK;
-			phy_write(phydev, ET1011C_CONFIG_REG, val\
-					| ET1011C_GMII_INTERFACE\
-					| ET1011C_SYS_CLK_EN\
-					| ET1011C_TX_FIFO_DEPTH_16);
+			phy_write(phydev, ET1011C_CONFIG_REG, val |
+					  ET1011C_GMII_INTERFACE |
+					  ET1011C_SYS_CLK_EN |
+					  ET1011C_TX_FIFO_DEPTH_16);
 
 		}
 	}