i2c-mxs: set controller to pio queue mode after reset

mxs_reset_block() clears the PIO_QUEUE_MODE bit. So we have
to set it again after a controller reset.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Cc: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>

drivers/i2c/busses/i2c-mxs.c

@@ -118,6 +118,8 @@ static void mxs_i2c_reset(struct mxs_i2c_dev *i2c)
 {
 	mxs_reset_block(i2c->regs);
 	writel(MXS_I2C_IRQ_MASK << 8, i2c->regs + MXS_I2C_CTRL1_SET);
+	writel(MXS_I2C_QUEUECTRL_PIO_QUEUE_MODE,
+			i2c->regs + MXS_I2C_QUEUECTRL_SET);
 }
 
 static void mxs_i2c_pioq_setup_read(struct mxs_i2c_dev *i2c, u8 addr, int len,
@@ -347,8 +349,6 @@ static int __devinit mxs_i2c_probe(struct platform_device *pdev)
 
 	/* Do reset to enforce correct startup after pinmuxing */
 	mxs_i2c_reset(i2c);
-	writel(MXS_I2C_QUEUECTRL_PIO_QUEUE_MODE,
-			i2c->regs + MXS_I2C_QUEUECTRL_SET);
 
 	adap = &i2c->adapter;
 	strlcpy(adap->name, "MXS I2C adapter", sizeof(adap->name));