[PATCH] skge: fix dma mask setup.

There are a couple of problems in the DMA setup code for skge.
* In the 64 bit case, it doesn't set the consistent mask.
* In the 32 bit case, the error check is backwards!
It likely will only be visible as a bug on 64 bit platforms.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

drivers/net/skge.c

@@ -3243,13 +3243,23 @@ static int __devinit skge_probe(struct pci_dev *pdev,
 
 	pci_set_master(pdev);
 
-	if (!(err = pci_set_dma_mask(pdev, DMA_64BIT_MASK)))
+	if (sizeof(dma_addr_t) > sizeof(u32) &&
+	    !(err = pci_set_dma_mask(pdev, DMA_64BIT_MASK))) {
 		using_dac = 1;
-	else if (!(err = pci_set_dma_mask(pdev, DMA_32BIT_MASK))) {
+		err = pci_set_consistent_dma_mask(pdev, DMA_64BIT_MASK);
+		if (err < 0) {
+			printk(KERN_ERR PFX "%s unable to obtain 64 bit DMA "
+			       "for consistent allocations\n", pci_name(pdev));
+			goto err_out_free_regions;
+		}
+	} else {
+		err = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
+		if (err) {
 			printk(KERN_ERR PFX "%s no usable DMA configuration\n",
 			       pci_name(pdev));
 			goto err_out_free_regions;
 		}
+	}
 
 #ifdef __BIG_ENDIAN
 	/* byte swap descriptors in hardware */