mac80211: don't use napi_gro_receive() outside NAPI context

commit 22d3a3c8 upstream.

No matter how the driver manages its NAPI context, there's no way
sending frames to it from a timer can be correct, since it would
corrupt the internal GRO lists.

To avoid that, always use the non-NAPI path when releasing frames
from the timer.
Reported-by: Jean Trivelly <jean.trivelly@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

net/mac80211/ieee80211_i.h

@@ -204,6 +204,8 @@ enum ieee80211_packet_rx_flags {
  * @IEEE80211_RX_CMNTR: received on cooked monitor already
  * @IEEE80211_RX_BEACON_REPORTED: This frame was already reported
  *	to cfg80211_report_obss_beacon().
+ * @IEEE80211_RX_REORDER_TIMER: this frame is released by the
+ *	reorder buffer timeout timer, not the normal RX path
  *
  * These flags are used across handling multiple interfaces
  * for a single frame.
@@ -211,6 +213,7 @@ enum ieee80211_packet_rx_flags {
 enum ieee80211_rx_flags {
 	IEEE80211_RX_CMNTR		= BIT(0),
 	IEEE80211_RX_BEACON_REPORTED	= BIT(1),
+	IEEE80211_RX_REORDER_TIMER	= BIT(2),
 };
 
 struct ieee80211_rx_data {

net/mac80211/rx.c

@@ -2106,7 +2106,8 @@ ieee80211_deliver_skb(struct ieee80211_rx_data *rx)
 		/* deliver to local stack */
 		skb->protocol = eth_type_trans(skb, dev);
 		memset(skb->cb, 0, sizeof(skb->cb));
-		if (rx->local->napi)
+		if (!(rx->flags & IEEE80211_RX_REORDER_TIMER) &&
+		    rx->local->napi)
 			napi_gro_receive(rx->local->napi, skb);
 		else
 			netif_receive_skb(skb);
@@ -3215,7 +3216,7 @@ void ieee80211_release_reorder_timeout(struct sta_info *sta, int tid)
 		/* This is OK -- must be QoS data frame */
 		.security_idx = tid,
 		.seqno_idx = tid,
-		.flags = 0,
+		.flags = IEEE80211_RX_REORDER_TIMER,
 	};
 	struct tid_ampdu_rx *tid_agg_rx;