atl1c: fix Mikrotik 10/25G NIC detection

Since Mikrotik 10/25G NIC MDIO op emulation is not 100% reliable,
on rare occasions it can happen that some physical functions of
the NIC do not get initialized due to timeouted early MDIO op.

This changes the atl1c probe on Mikrotik 10/25G NIC not to
depend on MDIO op emulation.
Signed-off-by: Gatis Peisenieks <gatis@mikrotik.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/atheros/atl1c/atl1c_hw.c

@@ -594,6 +594,11 @@ int atl1c_phy_init(struct atl1c_hw *hw)
 	int ret_val;
 	u16 mii_bmcr_data = BMCR_RESET;
 
+	if (hw->nic_type == athr_mt) {
+		hw->phy_configured = true;
+		return 0;
+	}
+
 	if ((atl1c_read_phy_reg(hw, MII_PHYSID1, &hw->phy_id1) != 0) ||
 		(atl1c_read_phy_reg(hw, MII_PHYSID2, &hw->phy_id2) != 0)) {
 		dev_err(&pdev->dev, "Error get phy ID\n");