[ISDN] Remove CONFIG_PCI ifdefs from 100% PCI source code

Signed-off-by: Jeff Garzik <jeff@garzik.org>

drivers/isdn/hisax/bkm_a8.c

@@ -20,8 +20,6 @@
 #include <linux/pci.h>
 #include "bkm_ax.h"
 
-#ifdef CONFIG_PCI
-
 #define	ATTEMPT_PCI_REMAPPING	/* Required for PLX rev 1 */
 
 extern const char *CardType[];
@@ -279,12 +277,9 @@ static u_char pci_bus __devinitdata = 0;
 static u_char pci_device_fn __devinitdata = 0;
 static u_char pci_irq __devinitdata = 0;
 
-#endif /* CONFIG_PCI */
-
 int __devinit
 setup_sct_quadro(struct IsdnCard *card)
 {
-#ifdef CONFIG_PCI
 	struct IsdnCardState *cs = card->cs;
 	char tmp[64];
 	u_int found = 0;
@@ -442,7 +437,4 @@ setup_sct_quadro(struct IsdnCard *card)
 		sct_quadro_subtypes[cs->subtyp],
 		readreg(cs->hw.ax.base, cs->hw.ax.data_adr, IPAC_ID));
 	return (1);
-#else
-	printk(KERN_ERR "HiSax: bkm_a8 only supported on PCI Systems\n");
-#endif /* CONFIG_PCI */
 }

drivers/isdn/hisax/telespci.c

@@ -295,11 +295,12 @@ setup_telespci(struct IsdnCard *card)
 #ifdef __BIG_ENDIAN
 #error "not running on big endian machines now"
 #endif
+
 	strcpy(tmp, telespci_revision);
 	printk(KERN_INFO "HiSax: Teles/PCI driver Rev. %s\n", HiSax_getrev(tmp));
 	if (cs->typ != ISDN_CTYPE_TELESPCI)
 		return (0);
-#ifdef CONFIG_PCI
+
 	if ((dev_tel = pci_find_device (PCI_VENDOR_ID_ZORAN, PCI_DEVICE_ID_ZORAN_36120, dev_tel))) {
 		if (pci_enable_device(dev_tel))
 			return(0);
@@ -317,11 +318,6 @@ setup_telespci(struct IsdnCard *card)
 		printk(KERN_WARNING "TelesPCI: No PCI card found\n");
 		return(0);
 	}
-#else
-	printk(KERN_WARNING "HiSax: Teles/PCI and NO_PCI_BIOS\n");
-	printk(KERN_WARNING "HiSax: Teles/PCI unable to config\n");
-	return (0);
-#endif /* CONFIG_PCI */
 
 	/* Initialize Zoran PCI controller */
 	writel(0x00000000, cs->hw.teles0.membase + 0x28);

drivers/isdn/hisax/w6692.c

@@ -1009,7 +1009,7 @@ setup_w6692(struct IsdnCard *card)
 	printk(KERN_INFO "HiSax: W6692 driver Rev. %s\n", HiSax_getrev(tmp));
 	if (cs->typ != ISDN_CTYPE_W6692)
 		return (0);
-#ifdef CONFIG_PCI
+
 	while (id_list[id_idx].vendor_id) {
 		dev_w6692 = pci_find_device(id_list[id_idx].vendor_id,
 					    id_list[id_idx].device_id,
@@ -1061,11 +1061,6 @@ setup_w6692(struct IsdnCard *card)
 		       cs->hw.w6692.iobase + 255);
 		return (0);
 	}
-#else
-	printk(KERN_WARNING "HiSax: W6692 and NO_PCI_BIOS\n");
-	printk(KERN_WARNING "HiSax: W6692 unable to config\n");
-	return (0);
-#endif				/* CONFIG_PCI */
 
 	printk(KERN_INFO
 	       "HiSax: %s config irq:%d I/O:%x\n",