Bluetooth: qca: Fix wrong event type for patch config command

Vendor-specific command patch config has HCI_Command_Complete event as
response, but qca_send_patch_config_cmd() wrongly expects vendor-specific
event for the command, fixed by using right event type.

Btmon log for the vendor-specific command are shown below:
< HCI Command: Vendor (0x3f|0x0000) plen 5
        28 01 00 00 00
> HCI Event: Command Complete (0x0e) plen 5
      Vendor (0x3f|0x0000) ncmd 1
        Status: Success (0x00)
        28

Fixes: 4fac8a7a ("Bluetooth: btqca: sequential validation")
Signed-off-by: Zijun Hu <quic_zijuhu@quicinc.com>
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>

drivers/bluetooth/btqca.c

@@ -152,7 +152,7 @@ static int qca_send_patch_config_cmd(struct hci_dev *hdev)
 	bt_dev_dbg(hdev, "QCA Patch config");
 
 	skb = __hci_cmd_sync_ev(hdev, EDL_PATCH_CMD_OPCODE, sizeof(cmd),
-				cmd, HCI_EV_VENDOR, HCI_INIT_TIMEOUT);
+				cmd, 0, HCI_INIT_TIMEOUT);
 	if (IS_ERR(skb)) {
 		err = PTR_ERR(skb);
 		bt_dev_err(hdev, "Sending QCA Patch config failed (%d)", err);