- 25 Feb, 2016 17 commits
-
-
Bruno Randolf authored
Monitor mode is enabled by handling the filter flags we get from mac80211 in rtl8xxxu_configure_filter() and writing them to the RCR register. By handling the filters, we can also stop setting the BSSID filters in the association event. Signed-off-by:
Bruno Randolf <br1@einfach.org> Signed-off-by:
Jes Sorensen <Jes.Sorensen@redhat.com> Signed-off-by:
Kalle Valo <kvalo@codeaurora.org>
-
Jes Sorensen authored
Signed-off-by:
-
Jakub Sitnicki authored
rtl8192cu driver doesn't read/write the REG_EFUSE_TEST register. Neither does the rtl8188eu driver. Do it only for multifunc devices RTL8723AU/RTL8723BU. Signed-off-by:
Jakub Sitnicki <jsitnicki@gmail.com> Signed-off-by:
-
Jes Sorensen authored
This was a leftover from the vendor driver that was never utilized. Signed-off-by:
-
Jes Sorensen authored
Signed-off-by:
-
Jes Sorensen authored
Signed-off-by:
-
Jes Sorensen authored
Signed-off-by:
-
Jes Sorensen authored
We need to reset the 8051 in order for it to launch the fw on the rtl8192eu. Signed-off-by:
-
Tobias Klauser authored
In rtl8xxxu_load_firmware() check the return value of kmemdup() and error out with -ENOMEM in case of NULL to prevent a NULL pointer dereference. Signed-off-by:
Tobias Klauser <tklauser@distanz.ch> Signed-off-by:
-
Tobias Klauser authored
Fix spelling of "benefits". Signed-off-by:
-
Jes Sorensen authored
Signed-off-by:
-
Jes Sorensen authored
Signed-off-by:
-
Jes Sorensen authored
This is needed for chips with IOL support. Signed-off-by:
-
Jes Sorensen authored
Signed-off-by:
-
Jes Sorensen authored
Signed-off-by:
-
Jes Sorensen authored
Signed-off-by:
-
Jes Sorensen authored
Signed-off-by:
-
- 19 Feb, 2016 2 commits
-
-
git://git.kernel.org/pub/scm/linux/kernel/git/jkirsher/next-queueDavid S. Miller authored
Jeff Kirsher says: ==================== 40GbE Intel Wired LAN Driver Updates 2016-02-18 This series contains updates to i40e and i40evf only. Alex Duyck provides all the patches in the series to update and fix the drivers. Fixed the driver to drop the outer checksum offload on UDP tunnels, since the issue is that the upper levels of the stack never requested such an offload and it results in possible errors. Updates the TSO function to just use u64 values, so we do not have to end up casting u32 values. In the TSO path, factored out the L4 header offsets allowing us to ignore the L4 header offsets when dealing with the L3 checksum and length update. Consolidates all of the spots where we were updating either the TCP or IP checksums in the TSO and checksum path into the TSO function. Fixed two issues by adding support for IPv4 encapsulated in IPv6, first issue was the fact that iphdr(skb)->protocol was being used to test for the outer transport protocol which breaks IPv6 support. The second was that we cleared the flag for v4 going to v6, but we did not take care of txflags going the other way. Added support for IPv6 extension headers in setting up the Tx checksum. Added exception handling to the Tx checksum path so that we can handle cases of TSO where the frame is bad, or Tx checksum where we did not recognize a protocol. Fixed a number of issues to make certain that we are using the correct protocols when parsing both the inner and outer headers of a frame that is mixed between IPv4 and IPv6 for inner and outer. Updated the feature flags to reflect the newly enabled/added features. Sorry, no witty patch descriptions this time around, probably should let Mitch help in writing patch descriptions for Alex. :-) ==================== Signed-off-by:David S. Miller <davem@davemloft.net>
-
Yuval Mintz authored
Commit e5d3a51c ("bnx2x: extend DCBx support") was missing HSI changes for big-endian machine, breaking compilation on such platforms. Reported-by:
kbuild test robot <fengguang.wu@intel.com> Signed-off-by:
Yuval Mintz <Yuval.Mintz@qlogic.com> Signed-off-by:
-
- 18 Feb, 2016 21 commits
-
-
Alexander Duyck authored
This patch updates the code for determining the L4 protocol and L3 header length so that when IPv6 extension headers are being used we can determine the offset and type of the L4 protocol. Signed-off-by:
Alexander Duyck <aduyck@mirantis.com> Tested-by:
Andrew Bowers <andrewx.bowers@intel.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com>
-
Alexander Duyck authored
Recent changes should have enabled support for IPv6 based tunnels and support for TSO with outer UDP checksums. As such we can update the feature flags to reflect that. In addition we can clean-up the flags that aren't needed such as SCTP and RXCSUM since having the bits there doesn't add any value. I also found one spot where we were setting the same flag twice. It looks like it was probably a git merge error that resulted in the line being duplicated. As such I have dropped it in this patch. Signed-off-by:
Anjali Singhai Jain <anjali.singhai@intel.com> Tested-by:
-
Alexander Duyck authored
Recent changes should have enabled support for IPv6 based tunnels and support for TSO with outer UDP checksums. As such we can update the feature flags to reflect that. In addition we can clean-up the flags that aren't needed such as SCTP and RXCSUM since having the bits there doesn't add any value. Signed-off-by:
-
Alexander Duyck authored
All of the documentation in the datasheets for the XL710 do not call out any reason to exclude support for IPv6 based tunnels. As such I am dropping the code that was excluding these tunnel types from having their port numbers recognized. This way we can take advantage of things such as checksum offload for inner headers over IPv6 based VXLAN or GENEVE tunnels. Signed-off-by:
-
Alexander Duyck authored
This patch contains a number of fixes to make certain that we are using the correct protocols when parsing both the inner and outer headers of a frame that is mixed between IPv4 and IPv6 for inner and outer. Signed-off-by:
Kiran Patil <kiran.patil@intel.com> Tested-by:
-
Alexander Duyck authored
The XL722 has support for providing the outer UDP tunnel checksum on transmits. Make use of this feature to support segmenting UDP tunnels with outer checksums enabled. Signed-off-by:
-
Alexander Duyck authored
This is mostly a minor clean-up for the Rx checksum path in order to avoid some of the unnecessary conditional checks that were being applied. Signed-off-by:
-
David S. Miller authored
Yuval Mintz says: ==================== qed{,e}: Add vlan filtering offload This series adds vlan filtering offload to qede. First patch introduces small additional infrastructure needed in qed to support it, while second contains the main bulk of driver changes. ==================== Signed-off-by: -
Sudarsana Reddy Kalluru authored
Device would start receiving only vlan-tagged traffic with tags matching that of one of the configured vlan IDs, unless: - Device is expliicly placed in PROMISC mode. - Device exhausts its vlan filter credits. Signed-off-by:
Sudarsana Reddy Kalluru <sudarsana.kalluru@qlogic.com> Signed-off-by:
-
Yuval Mintz authored
Today, interfaces are working in vlan-promisc mode; But once vlan filtering offloaded would be supported, we'll need a method to control it directly [e.g., when setting device to PROMISC, or when running out of vlan credits]. This adds the necessary API for L2 client to manually choose whether to accept all vlans or only those for which filters were configured. Signed-off-by:
-
Andrew F. Davis authored
Files in sysfs are created using the name from the phy_driver struct, when two names are the same we may get a duplicate filename warning, fix this. Reported-by:
kernel test robot <ying.huang@linux.intel.com> Signed-off-by:
Andrew F. Davis <afd@ti.com> Signed-off-by:
-
Alexander Duyck authored
This patch takes advantage of several assumptions we can make about the headers of the frame in order to reduce overall processing overhead for computing the outer header checksum. First we can assume the entire header is in the region pointed to by skb->head as this is what csum_start is based on. Second, as a result of our first assumption, we can just call csum_partial instead of making a call to skb_checksum which would end up having to configure things so that we could walk through the frags list. Signed-off-by:
-
Benjamin Poirier authored
follows up commit 45f6fad8 ("ipv6: add complete rcu protection around np->opt") which added mixed rcu/refcount protection to np->opt. Given the current implementation of rcu_pointer_handoff(), this has no effect at runtime. Signed-off-by:
Benjamin Poirier <bpoirier@suse.com> Acked-by:
Eric Dumazet <edumazet@google.com> Signed-off-by:
-
David S. Miller authored
Jiri Benc says: ==================== iptunnel: scrub packet in iptunnel_pull_header As every IP tunnel has to scrub skb on decapsulation, iptunnel_pull_header tried to do that and open coded part of skb_scrub_packet. Various tunneling protocols (VXLAN, Geneve) then called full skb_scrub_packet on their own, duplicating part of the scrubbing already done. Consolidate the code, calling skb_scrub_packet from iptunnel_pull_header. This will allow additional cleanups in VXLAN code, as the packet is scrubbed early during rx processing after this patchset and VXLAN can start filling out skb fields earlier. The full picture of vxlan cleanup patches can be seen at: https://github.com/jbenc/linux-vxlan/commits/master ==================== Signed-off-by:
-
Jiri Benc authored
Part of skb_scrub_packet was open coded in iptunnel_pull_header. Let it call skb_scrub_packet directly instead. Signed-off-by:
Jiri Benc <jbenc@redhat.com> Signed-off-by:
-
Jiri Benc authored
This is in preparation for iptunnel_pull_header calling skb_scrub_packet. Signed-off-by:
-
Jiri Benc authored
This is in preparation for iptunnel_pull_header calling skb_scrub_packet. Signed-off-by:
-
Jiri Benc authored
Similarly to the existing vxlan_get_sk_family. Signed-off-by:
-
Vivien Didelot authored
Remove the shared br_log_state function and print the info directly in br_set_state, where the net_bridge_port state is actually changed. Signed-off-by:
Vivien Didelot <vivien.didelot@savoirfairelinux.com> Acked-by:
Ido Schimmel <idosch@mellanox.com> Signed-off-by:
-
David S. Miller authored
Hariprasad Shenai says: ==================== cxgb4: Use __dev_[um]c_[un]sync for MAC address syncing This patch series adds support to use __dev_uc_sync/__dev_mc_sync to add MAC address and __dev_uc_unsync/__dev_mc_unsync to delete MAC address. This patch series has been created against net-next tree and includes patches on cxgb4 and cxgb4vf driver. We have included all the maintainers of respective drivers. Kindly review the change and let us know in case of any review comments. ==================== Signed-off-by: -
Hariprasad Shenai authored
Signed-off-by:
Hariprasad Shenai <hariprasad@chelsio.com> Signed-off-by:
-
