- 03 Feb, 2008 40 commits
-
-
Ayaz Abdulla authored
This patch updates the copyright section to include 2007 and 2008. Signed-off-by:
Ayaz Abdulla <aabdulla@nvidia.com> Signed-off-by:
Jeff Garzik <jeff@garzik.org> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Ayaz Abdulla authored
The driver should inform the stack when checksum has been performed by the HW when both IP and TCP (or UDP) checksum flags are indicated by HW. Previously, it would also inform the stack when only IP checksum flag was indicated by HW. This can cause data corruption when IP fragments are used. The IP Identification field can wrap around and cause data from new fragments to fill into older fragment slots with same IP Id. The stack would then not perform TCP/UDP checksum (after re-assembly of all fragments) since driver falsely stated it was already calculated. Signed-off-by:
-
Ayaz Abdulla authored
This patch fixes the reset register definition from 0x3C to 0x34. Signed-off-by:
-
Roel Kluin authored
include/linux/mii.h:48:#define BMCR_RESET 0x8000 The function reset_phy() is in "#if 0" inactivated code Replace logical "&&" by bit "&" before BMCR_RESET Signed-off-by:
Roel Kluin <12o3l@tiscali.nl> Signed-off-by:
-
Roland Dreier authored
When PCI error recovery was added to cxgb3, a function t3_io_slot_reset() was added. This function can call back into t3_prep_adapter() at any time, so t3_prep_adapter() can no longer be marked __devinit. This patch removes the __devinit annotation from t3_prep_adapter() and all the functions that it calls, which fixes WARNING: drivers/net/cxgb3/built-in.o(.text+0x2427): Section mismatch in reference from the function t3_io_slot_reset() to the function .devinit.text:t3_prep_adapter() Signed-off-by:Roland Dreier <rolandd@cisco.com> Signed-off-by:
-
Jay Vosburgh authored
Remove Chad Tindel; he hasn't been involved for a number of years. Signed-off-by:
Jay Vosburgh <fubar@us.ibm.com> Signed-off-by:
-
Jay Vosburgh authored
Update bonding to version 3.2.4. Signed-off-by:
-
Jay Vosburgh authored
The ARP monitor functions currently acquire RTNL when performing failover operations, but do so incorrectly (out of order). This causes various warnings from might_sleep. The ARP monitor isn't supported for any of the bonding modes that actually require RTNL, so it is safe to not hold RTNL when failing over in the ARP monitor. Signed-off-by:
-
Andy Gospodarek authored
I've seen reports of invalid stats in /proc/net/dev for bonding interfaces, and found it's a pretty easy problem to reproduce. Since the current code zeros the bonding stats when a read is requested and a pointer to that data is returned to the caller we cannot guarantee that the caller has completely accessed the data before a successive call to request the stats zeroes the stats again. This patch creates a new stack variable to keep track of the updated stats and copies the data from that variable into the bonding stats structure. This ensures that the value for any of the bonding stats should not incorrectly return zero for any of the bonding statistics. This does use more stack space and require an extra memcpy, but it seems like a fair trade-off for consistently correct bonding statistics. Signed-off-by:
Andy Gospodarek <andy@greyhouse.net> Signed-off-by:
Chris Snook <csnook@redhat.com> Acked-by:
-
Jay Vosburgh authored
Fix the "are we creating a duplicate" check to not compare the name if the name is NULL (meaning that the system should select a name). Bug reported by Benny Amorsen <benny+usenet@amorsen.dk>. Signed-off-by:
-
Jay Vosburgh authored
This patch eliminates a problem (reported by lockdep) in the bond_set_multicast_list function. It first reduces the locking on bond->lock to a simple read_lock, and second, adds netif_tx locking around the bonding mc_list manipulations that occur outside of the set_multicast_list function. The original problem was related to IPv6 addrconf activity. Signed-off-by:
-
Jay Vosburgh authored
My last fix (commit ece95f7f) didn't handle one case correctly. This resolves that, and it will now correctly parse parameters with arbitrary white space, and either text names or mode values. Signed-off-by:
-
Ralf Baechle authored
This is Thiemo's patch. ----- Forwarded message from Thiemo Seufer <ths@networkno.de> ----- From: Thiemo Seufer <ths@networkno.de> Date: Sat, 17 Nov 2007 22:29:13 +0000 To: netdev@vger.kernel.org Cc: linux-mips@linux-mips.org, ralf@linux-mips.org Subject: [PATCH, REPOST] Fix/Rewrite of the mipsnet driver Content-Type: text/plain; charset=us-ascii Hello All, currently the mipsnet driver fails after transmitting a number of packages because SKBs are allocated but never freed. I fixed that and coudn't refrain from removing the most egregious warts. - mipsnet.h folded into mipsnet.c, as it doesn't provide any useful external interface. - Free SKB after transmission. - Call free_irq in mipsnet_close, to balance the request_irq in mipsnet_open. - Removed duplicate read of rxDataCount. - Some identifiers are now less verbose. - Removed dead and/or unnecessarily complex code. - Code formatting fixes. Tested on Qemu's mipssim emulation, with this patch it can boot a Debian NFSroot. Thiemo Signed-off-by:
Thiemo Seufer <ths@networkno.de> Signed-off-by:
-
Adrian Bunk authored
- Peter's email address is bouncing - the project webpage no longer exists - neither Peter nor Mike had a single patch included in the kernel since 2.6.12-rc2 (when the git history begins) Signed-off-by:
Adrian Bunk <bunk@kernel.org> Signed-off-by:
-
Auke Kok authored
This removes a sparse warning. Signed-off-by:
Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by:
-
Andy Gospodarek authored
There's too much noise on systems that don't support MSI. Let's get rid of a few and make the real error message more specific. Signed-off-by:
-
Andreas Mohr authored
Signed-off-by:
Andreas Mohr <andi@lisas.de> Signed-off-by:
-
Adrian Bunk authored
This patch makes the needlessly global e1000_dump_eeprom() static. Signed-off-by:
-
Adrian Bunk authored
This patch makes the needlessly global reg_pattern_test_array() static. Signed-off-by:
-
Jiri Slaby authored
Patch against netdev-2.6 follows. -- writeX functions are not permitted on iomap-ped space change to iowriteX, also pci_unmap pci_map-ped space on exit (instead of iounmap). Signed-off-by:
Jiri Slaby <jirislaby@gmail.com> Signed-off-by:
-
Olof Johansson authored
Turns out we never disable the interface. It doesn't really cause any problems since the channel is off, but it's still better to do it this way. Signed-off-by:
Olof Johansson <olof@lixom.net> Signed-off-by:
-
Olof Johansson authored
Currently keeping it at 1500 bytes or below since jumbo frames need special checksum offload on TX. Signed-off-by:
-
Olof Johansson authored
Straightforward. It used to be hardcoded and impossible to override with ifconfig. Signed-off-by:
-
Surjit Reang authored
Resubmitting patch from Al Viro <viro@zeniv.linux.org.uk>, with subject - [PATCH] s2io LRO bugs. a) initiate_new_session() sets ->tcp_ack to ntohl(...); everything else stores and expects to find there the net-endian value. b) check for monotonic timestamps in verify_l3_l4_lro_capable() compares the value sitting in TCP option (right there in the skb->data, net-endian 32bit) with the value picked from earlier packet. Doing that without ntohl() is an interesting idea and it might even work occasionally; unfortunately, it's quite broken. Signed-off-by:
Surjit Reang <surjit.reang@neterion.com> Signed-off-by:
Ramkrishna Vepa <ram.vepa@neterion.com> Signed-off-by:
-
Nate Case authored
This Broadcom PHY is similar to other bcm54xx devices. Signed-off-by:
Nate Case <ncase@xes-inc.com> Signed-off-by:
-
Mitch Williams authored
Ethtool supports wake-on-ARP and wake-on-link, and so does the hardware supported by e1000e. This patch just introduces the two. Signed-off-by:
Mitch Williams <mitch.a.williams@intel.com> Signed-off-by:
-
Al Viro authored
* kill bitfields * annotate * add missing conversions * fix a couple of brainos in zerocopy stuff (fortunately, it's ifdef'ed out) Signed-off-by:
Al Viro <viro@zeniv.linux.org.uk> Signed-off-by:
-
Lennert Buytenhek authored
The RTL8150 driver uses an MTU of 1540 by default, which causes a bunch of problems -- it prevents booting from NFS root, for one. Signed-off-by:
Lennert Buytenhek <buytenh@wantstofly.org> Cc: Petko Manolov <petkan@nucleusys.com> Signed-off-by:
-
Adrian Bunk authored
This patch fixes the following section mismatch: <-- snip --> ... WARNING: drivers/net/sunbmac.o(.devinit.text+0x24): Section mismatch in reference from the function bigmac_sbus_probe() to the function .init.text:bigmac_ether_init() ... <-- snip --> Signed-off-by:
-
Adrian Bunk authored
This patch fixes the following section mismatch: <-- snip --> ... WARNING: drivers/net/sunqe.o(.devinit.text+0x4): Section mismatch in reference from the function qec_sbus_probe() to the function .init.text:qec_ether_init() ... <-- snip --> Signed-off-by:
-
Adrian Bunk authored
This patch fixes the following section mismatches: <-- snip --> ... WARNING: drivers/net/sunvnet.o(.text+0x220): Section mismatch in reference from the function print_version() to the variable .devinit.data:version WARNING: drivers/net/sunvnet.o(.text+0x228): Section mismatch in reference from the function print_version() to the variable .devinit.data:version ... <-- snip --> Signed-off-by:
-
Adrian Bunk authored
This patch removes the no longer required dependency of IBMLANA on MCA_LEGACY. Signed-off-by:
-
Adrian Bunk authored
This patch fixes the following section mismatch: <-- snip --> ... WARNING: drivers/net/built-in.o(.text+0x1148a5): Section mismatch in reference from the function ibmlana_init_one() to the variable .init.data:ibmlana_adapter_names ... <-- snip --> Signed-off-by:
-
Adrian Bunk authored
This patch fixes the following section mismatch: <-- snip --> ... WARNING: drivers/net/built-in.o(.text+0x155573): Section mismatch in reference from the function olympic_open() to the function .devinit.text:olympic_init() ... <-- snip --> Signed-off-by:
-
Adrian Bunk authored
This patch fixes the following section mismatch: <-- snip --> ... WARNING: drivers/net/built-in.o(.devinit.text+0x1baa4): Section mismatch in reference from the function ibmlana_init_one() to the variable .init.data:ibmlana_adapter_names ... <-- snip --> Signed-off-by:
-
Adrian Bunk authored
Thie patch fixes the following section mismatch: <-- snip --> ... WARNING: drivers/net/built-in.o(.text+0xdd840): Section mismatch in reference from the function rhine_hw_init() to the function .devinit.text:rhine_reload_eeprom() ... <-- snip --> Signed-off-by:
-
Ben Dooks authored
Change to using dev_dbg() and the other dev_xxx() macros instead of printk, and update to use the print_mac() helper. Signed-off-by:
Ben Dooks <ben-linux@fluff.org> Signed-off-by:
-
Haavard Skinnemoen authored
macb devices are only found integrated on SoCs, so they can't be hotplugged. Thus, the probe() and exit() functions can be __init and __exit, respectively. By using platform_driver_probe() instead of platform_driver_register(), there won't be any references to the discarded probe() function after the driver has loaded. This also fixes a section mismatch due to macb_probe(), defined as __devinit, calling macb_get_hwaddr, defined as __init. Signed-off-by:
Haavard Skinnemoen <hskinnemoen@atmel.com> Signed-off-by:
-
Jan-Bernd Themann authored
Due to changes in the struct device_driver there is no direct access to its kobj any longer. The kobj was used to create sysfs links between eHEA ethernet devices and the driver. This patch removes the affected sysfs links to resolve the build problems. Signed-off-by:
Jan-Bernd Themann <themann@de.ibm.com> Signed-off-by:
-
Anton Vorontsov authored
This patch adds netpoll support for the QE UCC Gigabit Ethernet driver. Tested using netconsole and KGDBoE. Signed-off-by:
Anton Vorontsov <avorontsov@ru.mvista.com> Signed-off-by:
-
