Commit 559e2f8b authored by Juliusz Chroboczek's avatar Juliusz Chroboczek

Tweak README for compatibility with markdown.

parent 018c9879
Babel
*****
=====
Babel is a loop-avoiding distance-vector routing protocol roughly
based on HSDV and AODV, but with provisions for link cost estimation
......@@ -7,7 +7,7 @@ and redistribution of routes from other routing protocols.
Installation
************
============
$ make
$ su -c 'make install'
......@@ -22,10 +22,10 @@ On Mac OS X, you'll need to do
Setting up a network for use with Babel
***************************************
=======================================
1. Set up every node's interface
================================
--------------------------------
On every node, set up the wireless interface:
......@@ -33,7 +33,7 @@ On every node, set up the wireless interface:
# ip link set up dev eth1
2. Set up every node's IP addresses
===================================
-----------------------------------
You will need to make sure that all of your nodes have a unique IPv6
address, and/or a unique IPv4 address.
......@@ -64,7 +64,7 @@ interface. This can be done by running e.g.
3. Start the routing daemon
===========================
---------------------------
Run Babel on every node, specifying the set of interfaces that it
should consider:
......@@ -78,7 +78,7 @@ the Babel network, just list them all:
4. Setting up an Internet gateway
=================================
---------------------------------
If you have one or more Internet gateways on your mesh network, you
will want to set them up so that they redistribute the default route.
......@@ -114,4 +114,4 @@ may want to consider autoconfiguring your routing domain using AHCP:
http://www.pps.jussieu.fr/~jch/software/ahcp/
Juliusz Chroboczek
-- Juliusz Chroboczek
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment