Commit 05f72e03 authored by Benoit Cousson's avatar Benoit Cousson Committed by Simon Horman

ARM: shmobile: lager: Add VDD MPU regulator for DVFS

The CA15 cluster is capable of voltage scaling. Add the regulator
in the i2c3 node, to allow the generic CPUFreq driver to use it.

Enable the i2c3 pin mux and the device node as well since the
da9210 is connected to that bus.

Note: In R-CAR Gen2, each frequency is using the same voltage,
and DVS control is not used. Therefore, this patch set the
voltage(Vmin/Vmax) to 1000mv.
Signed-off-by: default avatarBenoit Cousson <bcousson@baylibre.com>
[gaku.inami.xw@bp.renesas.com: Changes Vmin for disabling DVS]
Signed-off-by: default avatarGaku Inami <gaku.inami.xw@bp.renesas.com>
Acked-by: default avatarMagnus Damm <damm@opensource.se>
Signed-off-by: default avatarSimon Horman <horms+renesas@verge.net.au>
parent 4e074bc8
...@@ -204,6 +204,11 @@ msiof1_pins: spi2 { ...@@ -204,6 +204,11 @@ msiof1_pins: spi2 {
"msiof1_tx"; "msiof1_tx";
renesas,function = "msiof1"; renesas,function = "msiof1";
}; };
i2c3_pins: i2c3 {
renesas,groups = "i2c3";
renesas,function = "i2c3";
};
}; };
&ether { &ether {
...@@ -317,3 +322,19 @@ &sdhi2 { ...@@ -317,3 +322,19 @@ &sdhi2 {
cd-gpios = <&gpio3 22 GPIO_ACTIVE_LOW>; cd-gpios = <&gpio3 22 GPIO_ACTIVE_LOW>;
status = "okay"; status = "okay";
}; };
&i2c3 {
pinctrl-names = "default";
pinctrl-0 = <&i2c3_pins>;
status = "okay";
vdd_dvfs: regulator@68 {
compatible = "diasemi,da9210";
reg = <0x68>;
regulator-min-microvolt = <1000000>;
regulator-max-microvolt = <1000000>;
regulator-boot-on;
regulator-always-on;
};
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment