Commit 0630efee authored by Matthias Reichl's avatar Matthias Reichl Committed by Mauro Carvalho Chehab

media: rc: ite-cir: lower timeout and extend allowed timeout range

The minimum possible timeout of ite-cir is 8 samples, which is
typically about 70us. The driver however changes the FIFO trigger
level from the hardware's default of 1 byte to 17 bytes, so the minimum
usable timeout value is 17 * 8 samples, which is typically about 1.2ms.

Tests showed that using timeouts down to 1.2ms actually work fine.

The current default timeout of 200ms is much longer than necessary and
the maximum timeout of 1s seems to have been chosen a bit arbitrarily.

So change the minimum timeout to the driver's limit of 17 * 8 samples
and bring timeout and maximum timeout in line with the settings
of many other receivers.
Signed-off-by: default avatarMatthias Reichl <hias@horus.com>
Signed-off-by: default avatarSean Young <sean@mess.org>
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab+samsung@kernel.org>
parent 5dae9cea
......@@ -1561,9 +1561,11 @@ static int ite_probe(struct pnp_dev *pdev, const struct pnp_device_id
rdev->close = ite_close;
rdev->s_idle = ite_s_idle;
rdev->s_rx_carrier_range = ite_set_rx_carrier_range;
rdev->min_timeout = ITE_MIN_IDLE_TIMEOUT;
rdev->max_timeout = ITE_MAX_IDLE_TIMEOUT;
rdev->timeout = ITE_IDLE_TIMEOUT;
/* FIFO threshold is 17 bytes, so 17 * 8 samples minimum */
rdev->min_timeout = 17 * 8 * ITE_BAUDRATE_DIVISOR *
itdev->params.sample_period;
rdev->timeout = IR_DEFAULT_TIMEOUT;
rdev->max_timeout = 10 * IR_DEFAULT_TIMEOUT;
rdev->rx_resolution = ITE_BAUDRATE_DIVISOR *
itdev->params.sample_period;
rdev->tx_resolution = ITE_BAUDRATE_DIVISOR *
......
......@@ -154,13 +154,6 @@ struct ite_dev {
/* default carrier freq for when demodulator is off (Hz) */
#define ITE_DEFAULT_CARRIER_FREQ 38000
/* default idling timeout in ns (0.2 seconds) */
#define ITE_IDLE_TIMEOUT 200000000UL
/* limit timeout values */
#define ITE_MIN_IDLE_TIMEOUT 100000000UL
#define ITE_MAX_IDLE_TIMEOUT 1000000000UL
/* convert bits to us */
#define ITE_BITS_TO_NS(bits, sample_period) \
((u32) ((bits) * ITE_BAUDRATE_DIVISOR * sample_period))
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment