serial: 8250_dw: Honor clk_round_rate errors in dw8250_set_termios

clk_round_rate returns a signed long and may possibly return errors
in it, for example if there is no possible rate.

Till now dw8250_set_termios ignored any error, the signednes and would
just use the value as input to clk_set_rate. This of course falls apart
if there is an actual error, so check for errors and only try to set
a rate if the value is actually valid.

This turned up on some Rockchip platforms after commit
6a171b29 ("serial: 8250_dw: Allow hardware flow control to be used")
enabled set_termios callback in all cases, not only ACPI.

Fixes: 6a171b29 ("serial: 8250_dw: Allow hardware flow control to be used")
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/8250/8250_dw.c

@@ -257,7 +257,7 @@ static void dw8250_set_termios(struct uart_port *p, struct ktermios *termios,
 {
 	unsigned int baud = tty_termios_baud_rate(termios);
 	struct dw8250_data *d = p->private_data;
-	unsigned int rate;
+	long rate;
 	int ret;
 
 	if (IS_ERR(d->clk) || !old)
@@ -265,6 +265,9 @@ static void dw8250_set_termios(struct uart_port *p, struct ktermios *termios,
 
 	clk_disable_unprepare(d->clk);
 	rate = clk_round_rate(d->clk, baud * 16);
+	if (rate < 0)
+		ret = rate;
+	else
 		ret = clk_set_rate(d->clk, rate);
 	clk_prepare_enable(d->clk);