[PATCH] LifeView FlyTV Platinum FM: Remote Control support

Subject says it ...  this card's IR microcontroller design and attachment
are compatible to the company's previous designs, so the patch was as
simple as it gets.
DESC
LifeView FlyTV Platinum FM: GPIO usage
EDESC
From: Peter Missel <peter.missel@onlinehome.de>

This is take two of a patch that should have appeared two days ago, before
yesterday's "remote control" patch for the same card.

This patch sets unconnected GPIO to Output to keep them from floating (just
good driver writing practice, being nice to the chip), and uses GPIO16 to
switch TV vs.  FM - this pin switches inputs onto the tuner, as well as the
audio output from the tuner into the 7135 SIF input.  Consequently, FM
radio support is being un-commented because it's now working (sort of, see
below).

These two patches get the card almost fully operational; there appears to
be a bug in tda8290.c remaining that puts an offset onto the tuned
frequency in FM radio mode.  We're investigating.
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

drivers/media/video/saa7134/saa7134-cards.c

@@ -1948,6 +1948,7 @@ int saa7134_board_init1(struct saa7134_dev *dev)
 		dev->has_remote = 1;
 		board_flyvideo(dev);
 		break;
+	case SAA7134_BOARD_FLYTVPLATINUM_FM:
 	case SAA7134_BOARD_CINERGY400:
 	case SAA7134_BOARD_CINERGY600:
 	case SAA7134_BOARD_CINERGY600_MK3:

drivers/media/video/saa7134/saa7134-input.c

@@ -379,6 +379,7 @@ int saa7134_input_init1(struct saa7134_dev *dev)
 	switch (dev->board) {
 	case SAA7134_BOARD_FLYVIDEO2000:
 	case SAA7134_BOARD_FLYVIDEO3000:
+	case SAA7134_BOARD_FLYTVPLATINUM_FM:
 		ir_codes     = flyvideo_codes;
 		mask_keycode = 0xEC00000;
 		mask_keydown = 0x0040000;