Commit 133ace3f authored by Simon Horman's avatar Simon Horman

arm64: dts: ulcb: Set drive-strength for ravb pins

The EthernetAVB should not depend on the bootloader to setup correct
drive-strength values.  Values for drive-strength where found by
examining the registers after the bootloader has configured the
registers and successfully used the EthernetAVB.

Based on:
* commit 7d73a4da ("arm64: dts: r8a7795: salvator-x: Set drive-strength
  for ravb pins")
* commit 4903987033be ("arm64: dts: r8a7796: salvator-x: Set drive-strength
  for ravb pins")

Cc: Geert Uytterhoeven <geert+renesas@glider.be>
Cc: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>
Signed-off-by: default avatarSimon Horman <horms+renesas@verge.net.au>
Reviewed-by: default avatarGeert Uytterhoeven <geert+renesas@glider.be>
parent 428154de
......@@ -198,10 +198,24 @@ &pfc {
pinctrl-names = "default";
avb_pins: avb {
groups = "avb_mdc";
mux {
groups = "avb_link", "avb_phy_int", "avb_mdc",
"avb_mii";
function = "avb";
};
pins_mdc {
groups = "avb_mdc";
drive-strength = <24>;
};
pins_mii_tx {
pins = "PIN_AVB_TX_CTL", "PIN_AVB_TXC", "PIN_AVB_TD0",
"PIN_AVB_TD1", "PIN_AVB_TD2", "PIN_AVB_TD3";
drive-strength = <12>;
};
};
i2c2_pins: i2c2 {
groups = "i2c2_a";
function = "i2c2";
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment