r8169: use rtl8169_set_features in rtl8169_init_one

At that place in rtl_init_one() we can safely use rtl8169_set_features()
to configure the chip according to the default features.
Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/realtek/r8169_main.c

@@ -5446,10 +5446,6 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
 	dev->vlan_features = NETIF_F_SG | NETIF_F_IP_CSUM | NETIF_F_TSO;
 	dev->priv_flags |= IFF_LIVE_ADDR_CHANGE;
 
-	tp->cp_cmd |= RxChkSum;
-	/* RTL8125 uses register RxConfig for VLAN offloading config */
-	if (!rtl_is_8125(tp))
-		tp->cp_cmd |= RxVlan;
 	/*
 	 * Pretend we are using VLANs; This bypasses a nasty bug where
 	 * Interrupts stop flowing on high load on 8110SCd controllers.
@@ -5481,6 +5477,9 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
 	dev->hw_features |= NETIF_F_RXALL;
 	dev->hw_features |= NETIF_F_RXFCS;
 
+	/* configure chip for default features */
+	rtl8169_set_features(dev, dev->features);
+
 	jumbo_max = rtl_jumbo_max(tp);
 	if (jumbo_max)
 		dev->max_mtu = jumbo_max;