Commit 19f647cb authored by Laurent Pinchart's avatar Laurent Pinchart Committed by Simon Horman

ARM: shmobile: koelsch: Set ethernet PHY LED mode

The Koelsch board uses the ethernet PHY LED0 as a link signal connected
to the ethernet controller. Specify the corresponding LED mode for the
PHY.
Signed-off-by: default avatarLaurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Signed-off-by: default avatarSimon Horman <horms+renesas@verge.net.au>
parent f17dd09d
...@@ -297,6 +297,7 @@ phy1: ethernet-phy@1 { ...@@ -297,6 +297,7 @@ phy1: ethernet-phy@1 {
reg = <1>; reg = <1>;
interrupt-parent = <&irqc0>; interrupt-parent = <&irqc0>;
interrupts = <0 IRQ_TYPE_LEVEL_LOW>; interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
micrel,led-mode = <1>;
}; };
}; };
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment