i2c: driver for the Synopsys DesignWare I2C controller

The i2c Linux driver for the DesignWare i2c block of Synopsys, which is meant
for AMBA Peripheral Bus. This i2c block is used on SoC chips like the ARM9
based PVG610.
Signed-off-by: Baruch Siach <baruch@tkos.co.il>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>

drivers/i2c/busses/Kconfig

@@ -326,6 +326,15 @@ config I2C_DAVINCI
 	  devices such as DaVinci NIC.
 	  For details please see http://www.ti.com/davinci
 
+config I2C_DESIGNWARE
+	tristate "Synopsys DesignWare"
+	help
+	  If you say yes to this option, support will be included for the
+	  Synopsys DesignWare I2C adapter. Only master mode is supported.
+
+	  This driver can also be built as a module.  If so, the module
+	  will be called i2c-designware.
+
 config I2C_GPIO
 	tristate "GPIO-based bitbanging I2C"
 	depends on GENERIC_GPIO

drivers/i2c/busses/Makefile

@@ -30,6 +30,7 @@ obj-$(CONFIG_I2C_AU1550)	+= i2c-au1550.o
 obj-$(CONFIG_I2C_BLACKFIN_TWI)	+= i2c-bfin-twi.o
 obj-$(CONFIG_I2C_CPM)		+= i2c-cpm.o
 obj-$(CONFIG_I2C_DAVINCI)	+= i2c-davinci.o
+obj-$(CONFIG_I2C_DESIGNWARE)	+= i2c-designware.o
 obj-$(CONFIG_I2C_GPIO)		+= i2c-gpio.o
 obj-$(CONFIG_I2C_HIGHLANDER)	+= i2c-highlander.o
 obj-$(CONFIG_I2C_IBM_IIC)	+= i2c-ibm_iic.o