Commit 240e5464 authored by Adrian Bunk's avatar Adrian Bunk Committed by David S. Miller

[NET]: Remove Documentation/networking/Configurable

After more than 11 years this file does no longer contain much useful
information.
Signed-off-by: default avatarAdrian Bunk <bunk@kernel.org>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent b733c007
...@@ -4,8 +4,6 @@ ...@@ -4,8 +4,6 @@
- information on the 3Com EtherLink Plus (3c505) driver. - information on the 3Com EtherLink Plus (3c505) driver.
6pack.txt 6pack.txt
- info on the 6pack protocol, an alternative to KISS for AX.25 - info on the 6pack protocol, an alternative to KISS for AX.25
Configurable
- info on some of the configurable network parameters
DLINK.txt DLINK.txt
- info on the D-Link DE-600/DE-620 parallel port pocket adapters - info on the D-Link DE-600/DE-620 parallel port pocket adapters
PLIP.txt PLIP.txt
......
There are a few network parameters that can be tuned to better match
the kernel to your system hardware and intended usage. The defaults
are usually a good choice for 99% of the people 99% of the time, but
you should be aware they do exist and can be changed.
The current list of parameters can be found in the files:
linux/net/TUNABLE
Documentation/networking/ip-sysctl.txt
Some of these are accessible via the sysctl interface, and many more are
scheduled to be added in this way. For example, some parameters related
to Address Resolution Protocol (ARP) are very easily viewed and altered.
# cat /proc/sys/net/ipv4/arp_timeout
6000
# echo 7000 > /proc/sys/net/ipv4/arp_timeout
# cat /proc/sys/net/ipv4/arp_timeout
7000
Others are already accessible via the related user space programs.
For example, MAX_WINDOW has a default of 32 k which is a good choice for
modern hardware, but if you have a slow (8 bit) Ethernet card and/or a slow
machine, then this will be far too big for the card to keep up with fast
machines transmitting on the same net, resulting in overruns and receive errors.
A value of about 4 k would be more appropriate, which can be set via:
# route add -net 192.168.3.0 window 4096
The remainder of these can only be presently changed by altering a #define
in the related header file. This means an edit and recompile cycle.
Paul Gortmaker 06/96
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment