Commit 290eddc4 authored by John W. Linville's avatar John W. Linville
parents 8f7b8db6 3a40414f
......@@ -1218,6 +1218,7 @@ struct cfg80211_deauth_request {
const u8 *ie;
size_t ie_len;
u16 reason_code;
bool local_state_change;
};
/**
......
......@@ -3099,24 +3099,34 @@ static int ieee80211_prep_channel(struct ieee80211_sub_if_data *sdata,
ht_cfreq, ht_oper->primary_chan,
cbss->channel->band);
ht_oper = NULL;
} else {
channel_type = NL80211_CHAN_HT20;
}
}
if (ht_oper) {
channel_type = NL80211_CHAN_HT20;
if (ht_oper && sband->ht_cap.cap & IEEE80211_HT_CAP_SUP_WIDTH_20_40) {
/*
* cfg80211 already verified that the channel itself can
* be used, but it didn't check that we can do the right
* HT type, so do that here as well. If HT40 isn't allowed
* on this channel, disable 40 MHz operation.
*/
if (sband->ht_cap.cap & IEEE80211_HT_CAP_SUP_WIDTH_20_40) {
switch (ht_oper->ht_param &
IEEE80211_HT_PARAM_CHA_SEC_OFFSET) {
switch (ht_oper->ht_param & IEEE80211_HT_PARAM_CHA_SEC_OFFSET) {
case IEEE80211_HT_PARAM_CHA_SEC_ABOVE:
if (cbss->channel->flags & IEEE80211_CHAN_NO_HT40PLUS)
ifmgd->flags |= IEEE80211_STA_DISABLE_40MHZ;
else
channel_type = NL80211_CHAN_HT40PLUS;
break;
case IEEE80211_HT_PARAM_CHA_SEC_BELOW:
if (cbss->channel->flags & IEEE80211_CHAN_NO_HT40MINUS)
ifmgd->flags |= IEEE80211_STA_DISABLE_40MHZ;
else
channel_type = NL80211_CHAN_HT40MINUS;
break;
}
}
}
if (!ieee80211_set_channel_type(local, sdata, channel_type)) {
/* can only fail due to HT40+/- mismatch */
......@@ -3549,6 +3559,7 @@ int ieee80211_mgd_deauth(struct ieee80211_sub_if_data *sdata,
{
struct ieee80211_if_managed *ifmgd = &sdata->u.mgd;
u8 frame_buf[IEEE80211_DEAUTH_FRAME_LEN];
bool tx = !req->local_state_change;
mutex_lock(&ifmgd->mtx);
......@@ -3565,12 +3576,12 @@ int ieee80211_mgd_deauth(struct ieee80211_sub_if_data *sdata,
if (ifmgd->associated &&
ether_addr_equal(ifmgd->associated->bssid, req->bssid)) {
ieee80211_set_disassoc(sdata, IEEE80211_STYPE_DEAUTH,
req->reason_code, true, frame_buf);
req->reason_code, tx, frame_buf);
} else {
drv_mgd_prepare_tx(sdata->local, sdata);
ieee80211_send_deauth_disassoc(sdata, req->bssid,
IEEE80211_STYPE_DEAUTH,
req->reason_code, true,
req->reason_code, tx,
frame_buf);
}
......
......@@ -546,14 +546,19 @@ ieee80211_crypto_ccmp_decrypt(struct ieee80211_rx_data *rx)
static void bip_aad(struct sk_buff *skb, u8 *aad)
{
__le16 mask_fc;
struct ieee80211_hdr *hdr = (struct ieee80211_hdr *) skb->data;
/* BIP AAD: FC(masked) || A1 || A2 || A3 */
/* FC type/subtype */
aad[0] = skb->data[0];
/* Mask FC Retry, PwrMgt, MoreData flags to zero */
aad[1] = skb->data[1] & ~(BIT(4) | BIT(5) | BIT(6));
mask_fc = hdr->frame_control;
mask_fc &= ~cpu_to_le16(IEEE80211_FCTL_RETRY | IEEE80211_FCTL_PM |
IEEE80211_FCTL_MOREDATA);
put_unaligned(mask_fc, (__le16 *) &aad[0]);
/* A1 || A2 || A3 */
memcpy(aad + 2, skb->data + 4, 3 * ETH_ALEN);
memcpy(aad + 2, &hdr->addr1, 3 * ETH_ALEN);
}
......
......@@ -457,20 +457,14 @@ int __cfg80211_mlme_deauth(struct cfg80211_registered_device *rdev,
.reason_code = reason,
.ie = ie,
.ie_len = ie_len,
.local_state_change = local_state_change,
};
ASSERT_WDEV_LOCK(wdev);
if (local_state_change) {
if (wdev->current_bss &&
ether_addr_equal(wdev->current_bss->pub.bssid, bssid)) {
cfg80211_unhold_bss(wdev->current_bss);
cfg80211_put_bss(&wdev->current_bss->pub);
wdev->current_bss = NULL;
}
if (local_state_change && (!wdev->current_bss ||
!ether_addr_equal(wdev->current_bss->pub.bssid, bssid)))
return 0;
}
return rdev->ops->deauth(&rdev->wiphy, dev, &req);
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment