mmc: tmio: enable SoC specific DMA buswidth settings

Renesas SDHI which is based on TMIO driver has 2 type SoC. 1st one is
used as SH-Mobile series, and 2nd is R-Car series. R-Car series SoC has
DMA buswidth setting register which enables 32bit access.
This patch adds .dma_buswidth and enables it.
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/tmio_mmc.h

@@ -16,6 +16,7 @@
 #ifndef TMIO_MMC_H
 #define TMIO_MMC_H
 
+#include <linux/dmaengine.h>
 #include <linux/highmem.h>
 #include <linux/mmc/tmio.h>
 #include <linux/mutex.h>
@@ -46,6 +47,7 @@ struct tmio_mmc_dma {
 	void *chan_priv_rx;
 	int slave_id_tx;
 	int slave_id_rx;
+	enum dma_slave_buswidth dma_buswidth;
 	bool (*filter)(struct dma_chan *chan, void *arg);
 	void (*enable)(struct tmio_mmc_host *host, bool enable);
 };

drivers/mmc/host/tmio_mmc_dma.c

@@ -293,6 +293,8 @@ void tmio_mmc_request_dma(struct tmio_mmc_host *host, struct tmio_mmc_data *pdat
 			cfg.slave_id = host->dma->slave_id_tx;
 		cfg.direction = DMA_MEM_TO_DEV;
 		cfg.dst_addr = res->start + (CTL_SD_DATA_PORT << host->bus_shift);
+		cfg.dst_addr_width = host->dma->dma_buswidth;
+		if (!cfg.dst_addr_width)
 			cfg.dst_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
 		cfg.src_addr = 0;
 		ret = dmaengine_slave_config(host->chan_tx, &cfg);
@@ -312,6 +314,8 @@ void tmio_mmc_request_dma(struct tmio_mmc_host *host, struct tmio_mmc_data *pdat
 			cfg.slave_id = host->dma->slave_id_rx;
 		cfg.direction = DMA_DEV_TO_MEM;
 		cfg.src_addr = cfg.dst_addr + host->pdata->dma_rx_offset;
+		cfg.src_addr_width = host->dma->dma_buswidth;
+		if (!cfg.src_addr_width)
 			cfg.src_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
 		cfg.dst_addr = 0;
 		ret = dmaengine_slave_config(host->chan_rx, &cfg);