mlx4_en: use NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM for tx csum at initialization

The former usage was to set the NETIF_F_HW_CSUM flag which is not used
in get_tx_csum. It caused Ethtool to show tx checksum as "on" even
though it was turned off in previous operation.
Signed-off-by: Yevgeny Petrilin <yevgenyp@mellanox.co.il>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/mlx4/en_netdev.c

@@ -1057,7 +1057,7 @@ int mlx4_en_init_netdev(struct mlx4_en_dev *mdev, int port,
 	 * Set driver features
 	 */
 	dev->features |= NETIF_F_SG;
-	dev->features |= NETIF_F_HW_CSUM;
+	dev->features |= NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM;
 	dev->features |= NETIF_F_HIGHDMA;
 	dev->features |= NETIF_F_HW_VLAN_TX |
 			 NETIF_F_HW_VLAN_RX |