Bluetooth: Fix conditions for HCI_Delete_Stored_Link_Key
Even though the HCI_Delete_Stored_Link_Key command is mandatory for 1.1 and later controllers some controllers do not seem to support it properly as was witnessed by one Broadcom based controller: < HCI Command: Delete Stored Link Key (0x03|0x0012) plen 7 bdaddr 00:00:00:00:00:00 all 1 > HCI Event: Command Complete (0x0e) plen 4 Delete Stored Link Key (0x03|0x0012) ncmd 1 status 0x11 deleted 0 Error: Unsupported Feature or Parameter Value Luckily this same controller also doesn't list the command in its supported commands bit mask (counting from 0 bit 7 of octet 6): < HCI Command: Read Local Supported Commands (0x04|0x0002) plen 0 > HCI Event: Command Complete (0x0e) plen 68 Read Local Supported Commands (0x04|0x0002) ncmd 1 status 0x00 Commands: ffffffffffff1ffffffffffff30fffff3f Therefore, it makes sense to move sending of HCI_Delete_Stored_Link_Key to after receiving the supported commands response and to only send it if its respective bit in the mask is set. The downside of this is that we no longer send the HCI_Delete_Stored_Link_Key command for Bluetooth 1.1 controllers since HCI_Read_Local_Supported_Command was introduced in version 1.2, but this is an acceptable penalty as the command in question shouldn't affect critical behavior. Reported-by: Pavel Machek <pavel@ucw.cz> Signed-off-by: Johan Hedberg <johan.hedberg@intel.com> Tested-by: Pavel Machek <pavel@ucw.cz> Signed-off-by: Gustavo Padovan <gustavo.padovan@collabora.co.uk> Signed-off-by: John W. Linville <linville@tuxdriver.com>
Showing
Please register or sign in to comment