usb: dwc3: gadget: move AcceptU1Ena and AcceptU2Ena to Reset IRQ

According to the databook, the DWC3 Core will
reset those bits to 0 on USB Bus Reset. This
means we must re-enable those bits on every
reset interrupt.

Because we will always get a Reset interrupt
after loading a gadget driver, we can, instead
of re-enabling something that was just lost,
move the handling of those bits to the Reset
Interrupt.

This patch fixes USB30CV U1/U2 Test.
Signed-off-by: Gerard CAUVY <g-cauvy1@ti.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>

drivers/usb/dwc3/gadget.c

@@ -2006,6 +2006,7 @@ static void dwc3_gadget_reset_interrupt(struct dwc3 *dwc)
 	reg = dwc3_readl(dwc->regs, DWC3_DCTL);
 	reg &= ~DWC3_DCTL_TSTCTRL_MASK;
 	reg &= ~(DWC3_DCTL_INITU1ENA | DWC3_DCTL_INITU2ENA);
+	reg |= (DWC3_DCTL_ACCEPTU1ENA | DWC3_DCTL_ACCEPTU2ENA);
 	dwc3_writel(dwc->regs, DWC3_DCTL, reg);
 	dwc->test_mode = false;
 
@@ -2410,10 +2411,6 @@ int __devinit dwc3_gadget_init(struct dwc3 *dwc)
 	reg |= DWC3_DCFG_LPM_CAP;
 	dwc3_writel(dwc->regs, DWC3_DCFG, reg);
 
-	reg = dwc3_readl(dwc->regs, DWC3_DCTL);
-	reg |= DWC3_DCTL_ACCEPTU1ENA | DWC3_DCTL_ACCEPTU2ENA;
-	dwc3_writel(dwc->regs, DWC3_DCTL, reg);
-
 	/* Enable all but Start and End of Frame IRQs */
 	reg = (DWC3_DEVTEN_VNDRDEVTSTRCVEDEN |
 			DWC3_DEVTEN_EVNTOVERFLOWEN |