mtd: nand: add NAND_BUSWIDTH_AUTO to autodetect bus width

The driver call nand_scan_ident in 8 bit mode, then
readid or onfi detection are done (and detect bus width).
The driver should update its bus width before calling nand_scan_tail.

This work because readid and onfi are read work 8 byte mode.

Note that nand_scan_ident send command (NAND_CMD_RESET, NAND_CMD_READID, NAND_CMD_PARAM), address and read data
The ONFI specificication is not very clear for x16 device if high byte of address should be driven to 0,
but according to [1] it should be ok to not drive it during autodetection.

[1]
3.3.2. Target Initialization

[...]
The Read ID and Read Parameter Page commands only use the lower 8-bits of the data bus.
The host shall not issue commands that use a word data width on x16 devices until the host
determines the device supports a 16-bit data bus width in the parameter page.
Signed-off-by: Matthieu CASTET <matthieu.castet@parrot.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>

drivers/mtd/nand/nand_base.c

@@ -3250,11 +3250,15 @@ static struct nand_flash_dev *nand_get_flash_type(struct mtd_info *mtd,
 			break;
 	}
 
+	if (chip->options & NAND_BUSWIDTH_AUTO) {
+		WARN_ON(chip->options & NAND_BUSWIDTH_16);
+		chip->options |= busw;
+		nand_set_defaults(chip, busw);
+	} else if (busw != (chip->options & NAND_BUSWIDTH_16)) {
 		/*
 		 * Check, if buswidth is correct. Hardware drivers should set
 		 * chip correct!
 		 */
-	if (busw != (chip->options & NAND_BUSWIDTH_16)) {
 		pr_info("NAND device: Manufacturer ID:"
 			" 0x%02x, Chip ID: 0x%02x (%s %s)\n", *maf_id,
 			*dev_id, nand_manuf_ids[maf_idx].name, mtd->name);

include/linux/mtd/nand.h

@@ -219,6 +219,13 @@ typedef enum {
 #define NAND_OWN_BUFFERS	0x00020000
 /* Chip may not exist, so silence any errors in scan */
 #define NAND_SCAN_SILENT_NODEV	0x00040000
+/*
+ * Autodetect nand buswidth with readid/onfi.
+ * This suppose the driver will configure the hardware in 8 bits mode
+ * when calling nand_scan_ident, and update its configuration
+ * before calling nand_scan_tail.
+ */
+#define NAND_BUSWIDTH_AUTO      0x00080000
 
 /* Options set by nand scan */
 /* Nand scan has allocated controller struct */