gpio/omap: fix incorrect access of debounce module

Enable debounce clock before writing/reading debounce registers.
Disable the clock at the end so that it is synchronized with the
pm_runtime_get/put_sync calls.

Enable debounce clock per module. This call is mandatory because
in omap_gpio_request() when *_runtime_get_sync() is called,
_gpio_dbck_enable() within runtime callbck fails to turn on dbck
 because dbck_enable_mask used within _gpio_dbck_enable() is still
not initialized at that point. Therefore we have to enable dbck here.
Signed-off-by: Tarun Kanti DebBarma <tarun.kanti@ti.com>
Reviewed-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Reviewed-by: Kevin Hilman <khilman@ti.com>
Signed-off-by: Kevin Hilman <khilman@ti.com>

drivers/gpio/gpio-omap.c

@@ -203,22 +203,30 @@ static void _set_gpio_debounce(struct gpio_bank *bank, unsigned gpio,
 
 	l = GPIO_BIT(bank, gpio);
 
+	clk_enable(bank->dbck);
 	reg = bank->base + bank->regs->debounce;
 	__raw_writel(debounce, reg);
 
 	reg = bank->base + bank->regs->debounce_en;
 	val = __raw_readl(reg);
 
-	if (debounce) {
+	if (debounce)
 		val |= l;
-		clk_enable(bank->dbck);
-	} else {
+	else
 		val &= ~l;
-		clk_disable(bank->dbck);
-	}
 	bank->dbck_enable_mask = val;
 
 	__raw_writel(val, reg);
+	clk_disable(bank->dbck);
+	/*
+	 * Enable debounce clock per module.
+	 * This call is mandatory because in omap_gpio_request() when
+	 * *_runtime_get_sync() is called,  _gpio_dbck_enable() within
+	 * runtime callbck fails to turn on dbck because dbck_enable_mask
+	 * used within _gpio_dbck_enable() is still not initialized at
+	 * that point. Therefore we have to enable dbck here.
+	 */
+	_gpio_dbck_enable(bank);
 }
 
 static inline void set_gpio_trigger(struct gpio_bank *bank, int gpio,