Commit 7f821875 authored by Jesse Brandeburg's avatar Jesse Brandeburg Committed by Jeff Garzik

ixgbe: refresh the ixgbe_down function

clean up the hardware shutdown sequence to prevent hardware
from continuing to send when resetting or unloading.
Signed-off-by: default avatarJesse Brandeburg <jesse.brandeburg@intel.com>
Signed-off-by: default avatarJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: default avatarJeff Garzik <jgarzik@redhat.com>
parent c44ade9e
......@@ -1096,7 +1096,7 @@ static int ixgbe_clean_rxonly_many(struct napi_struct *napi, int budget)
r_idx = find_first_bit(q_vector->rxr_idx, adapter->num_rx_queues);
rx_ring = &(adapter->rx_ring[r_idx]);
/* If all Rx work done, exit the polling mode */
if ((work_done == 0) || !netif_running(netdev)) {
if (work_done < budget) {
netif_rx_complete(netdev, napi);
if (adapter->itr_setting & 3)
ixgbe_set_itr_msix(q_vector);
......@@ -2174,32 +2174,41 @@ static void ixgbe_clean_all_tx_rings(struct ixgbe_adapter *adapter)
void ixgbe_down(struct ixgbe_adapter *adapter)
{
struct net_device *netdev = adapter->netdev;
struct ixgbe_hw *hw = &adapter->hw;
u32 rxctrl;
u32 txdctl;
int i, j;
/* signal that we are down to the interrupt handler */
set_bit(__IXGBE_DOWN, &adapter->state);
/* disable receives */
rxctrl = IXGBE_READ_REG(&adapter->hw, IXGBE_RXCTRL);
IXGBE_WRITE_REG(&adapter->hw, IXGBE_RXCTRL,
rxctrl & ~IXGBE_RXCTRL_RXEN);
rxctrl = IXGBE_READ_REG(hw, IXGBE_RXCTRL);
IXGBE_WRITE_REG(hw, IXGBE_RXCTRL, rxctrl & ~IXGBE_RXCTRL_RXEN);
netif_tx_disable(netdev);
/* disable transmits in the hardware */
/* flush both disables */
IXGBE_WRITE_FLUSH(&adapter->hw);
IXGBE_WRITE_FLUSH(hw);
msleep(10);
netif_tx_stop_all_queues(netdev);
ixgbe_irq_disable(adapter);
ixgbe_napi_disable_all(adapter);
del_timer_sync(&adapter->watchdog_timer);
cancel_work_sync(&adapter->watchdog_task);
/* disable transmits in the hardware now that interrupts are off */
for (i = 0; i < adapter->num_tx_queues; i++) {
j = adapter->tx_ring[i].reg_idx;
txdctl = IXGBE_READ_REG(hw, IXGBE_TXDCTL(j));
IXGBE_WRITE_REG(hw, IXGBE_TXDCTL(j),
(txdctl & ~IXGBE_TXDCTL_ENABLE));
}
netif_carrier_off(netdev);
netif_tx_stop_all_queues(netdev);
#if defined(CONFIG_DCA) || defined(CONFIG_DCA_MODULE)
if (adapter->flags & IXGBE_FLAG_DCA_ENABLED) {
......@@ -2219,7 +2228,7 @@ void ixgbe_down(struct ixgbe_adapter *adapter)
adapter->flags |= IXGBE_FLAG_DCA_ENABLED;
/* always use CB2 mode, difference is masked
* in the CB driver */
IXGBE_WRITE_REG(&adapter->hw, IXGBE_DCA_CTRL, 2);
IXGBE_WRITE_REG(hw, IXGBE_DCA_CTRL, 2);
ixgbe_setup_dca(adapter);
}
#endif
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment