sfc: Fix naming of MTD partitions for FPGA bitfiles

efx_mcdi_get_board_cfg() uses a buffer for the firmware response that
is only large enough to hold subtypes for the originally defined set
of NVRAM partitions.  Longer responses are truncated, and we may read
off the end of the buffer when copying out subtypes for additional
partitions.  In particular, this can result in the MTD partition for
an FPGA bitfile being named e.g. 'eth5 sfc_fpga:00' when it should be
'eth5 sfc_fpga:01'.  This means the firmware update tool (sfupdate)
can't tell which bitfile should be written to the partition.

Correct the response buffer size.
Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/sfc/mcdi.c

@@ -667,7 +667,7 @@ int efx_mcdi_drv_attach(struct efx_nic *efx, bool driver_operating,
 int efx_mcdi_get_board_cfg(struct efx_nic *efx, u8 *mac_address,
 			   u16 *fw_subtype_list, u32 *capabilities)
 {
-	uint8_t outbuf[MC_CMD_GET_BOARD_CFG_OUT_LENMIN];
+	uint8_t outbuf[MC_CMD_GET_BOARD_CFG_OUT_LENMAX];
 	size_t outlen, offset, i;
 	int port_num = efx_port_num(efx);
 	int rc;