Commit 8b900507 authored by Sergio Paracuellos's avatar Sergio Paracuellos Committed by Greg Kroah-Hartman

staging: mt7621-gpio: make use 'bgpio_init' from GPIO_GENERIC

Gpio complexity is just masking the fact that offset is always
0..n and writes to bits 0..n of some memory address. Because
of this whole thing can just me converted to use GPIO_GENERIC
and avoid duplications of a lot of driver custom functions.
So use bgpio_init instead of custom code adding GPIO_GENERIC
dependency to the Kconfig file. Also to make easier using
bgpio_init function offset for each gpio bank, enumeration
where register were defined has been replaced in favour of
some macros which handle each gpio offset taking into account
the bank where are located. Because of this change write and
read functions which are being used for remaining irq handling
stuff have been updated also as well as its dependencies along
the code.
Signed-off-by: default avatarSergio Paracuellos <sergio.paracuellos@gmail.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 144e2643
config GPIO_MT7621
bool "Mediatek GPIO Support"
depends on SOC_MT7620 || SOC_MT7621
select GPIO_GENERIC
select ARCH_REQUIRE_GPIOLIB
help
Say yes here to support the Mediatek SoC GPIO device
......@@ -19,19 +19,18 @@
#define MTK_BANK_WIDTH 32
#define PIN_MASK(nr) (1UL << ((nr % MTK_BANK_WIDTH)))
enum mediatek_gpio_reg {
GPIO_REG_CTRL = 0,
GPIO_REG_POL,
GPIO_REG_DATA,
GPIO_REG_DSET,
GPIO_REG_DCLR,
GPIO_REG_REDGE,
GPIO_REG_FEDGE,
GPIO_REG_HLVL,
GPIO_REG_LLVL,
GPIO_REG_STAT,
GPIO_REG_EDGE,
};
#define GPIO_BANK_WIDE 0x04
#define GPIO_REG_CTRL 0x00
#define GPIO_REG_POL 0x10
#define GPIO_REG_DATA 0x20
#define GPIO_REG_DSET 0x30
#define GPIO_REG_DCLR 0x40
#define GPIO_REG_REDGE 0x50
#define GPIO_REG_FEDGE 0x60
#define GPIO_REG_HLVL 0x70
#define GPIO_REG_LLVL 0x80
#define GPIO_REG_STAT 0x90
#define GPIO_REG_EDGE 0xA0
struct mtk_gc {
struct gpio_chip chip;
......@@ -55,80 +54,23 @@ to_mediatek_gpio(struct gpio_chip *chip)
}
static inline void
mtk_gpio_w32(struct mtk_gc *rg, u8 reg, u32 val)
mtk_gpio_w32(struct mtk_gc *rg, u32 offset, u32 val)
{
struct mtk_data *gpio_data = gpiochip_get_data(&rg->chip);
u32 offset = (reg * 0x10) + (rg->bank * 0x4);
struct gpio_chip *gc = &rg->chip;
struct mtk_data *gpio_data = gpiochip_get_data(gc);
iowrite32(val, gpio_data->gpio_membase + offset);
offset = (rg->bank * GPIO_BANK_WIDE) + offset;
gc->write_reg(gpio_data->gpio_membase + offset, val);
}
static inline u32
mtk_gpio_r32(struct mtk_gc *rg, u8 reg)
{
struct mtk_data *gpio_data = gpiochip_get_data(&rg->chip);
u32 offset = (reg * 0x10) + (rg->bank * 0x4);
return ioread32(gpio_data->gpio_membase + offset);
}
static void
mediatek_gpio_set(struct gpio_chip *chip, unsigned int offset, int value)
{
struct mtk_gc *rg = to_mediatek_gpio(chip);
mtk_gpio_w32(rg, (value) ? GPIO_REG_DSET : GPIO_REG_DCLR, BIT(offset));
}
static int
mediatek_gpio_get(struct gpio_chip *chip, unsigned int offset)
{
struct mtk_gc *rg = to_mediatek_gpio(chip);
return !!(mtk_gpio_r32(rg, GPIO_REG_DATA) & BIT(offset));
}
static int
mediatek_gpio_direction_input(struct gpio_chip *chip, unsigned int offset)
{
struct mtk_gc *rg = to_mediatek_gpio(chip);
unsigned long flags;
u32 t;
spin_lock_irqsave(&rg->lock, flags);
t = mtk_gpio_r32(rg, GPIO_REG_CTRL);
t &= ~BIT(offset);
mtk_gpio_w32(rg, GPIO_REG_CTRL, t);
spin_unlock_irqrestore(&rg->lock, flags);
return 0;
}
static int
mediatek_gpio_direction_output(struct gpio_chip *chip,
unsigned int offset, int value)
mtk_gpio_r32(struct mtk_gc *rg, u32 offset)
{
struct mtk_gc *rg = to_mediatek_gpio(chip);
unsigned long flags;
u32 t;
struct gpio_chip *gc = &rg->chip;
struct mtk_data *gpio_data = gpiochip_get_data(gc);
spin_lock_irqsave(&rg->lock, flags);
t = mtk_gpio_r32(rg, GPIO_REG_CTRL);
t |= BIT(offset);
mtk_gpio_w32(rg, GPIO_REG_CTRL, t);
mediatek_gpio_set(chip, offset, value);
spin_unlock_irqrestore(&rg->lock, flags);
return 0;
}
static int
mediatek_gpio_get_direction(struct gpio_chip *chip, unsigned int offset)
{
struct mtk_gc *rg = to_mediatek_gpio(chip);
u32 t = mtk_gpio_r32(rg, GPIO_REG_CTRL);
return (t & BIT(offset)) ? GPIOF_DIR_OUT : GPIOF_DIR_IN;
offset = (rg->bank * GPIO_BANK_WIDE) + offset;
return gc->read_reg(gpio_data->gpio_membase + offset);
}
static int
......@@ -144,34 +86,38 @@ mediatek_gpio_to_irq(struct gpio_chip *chip, unsigned int pin)
static int
mediatek_gpio_bank_probe(struct platform_device *pdev, struct device_node *bank)
{
struct mtk_data *gpio_data = dev_get_drvdata(&pdev->dev);
struct mtk_data *gpio = dev_get_drvdata(&pdev->dev);
const __be32 *id = of_get_property(bank, "reg", NULL);
struct mtk_gc *rg;
void __iomem *dat, *set, *ctrl, *diro;
int ret;
if (!id || be32_to_cpu(*id) >= MTK_BANK_CNT)
return -EINVAL;
rg = &gpio_data->gc_map[be32_to_cpu(*id)];
rg = &gpio->gc_map[be32_to_cpu(*id)];
memset(rg, 0, sizeof(*rg));
spin_lock_init(&rg->lock);
rg->chip.parent = &pdev->dev;
rg->chip.label = dev_name(&pdev->dev);
rg->chip.of_node = bank;
rg->chip.base = MTK_BANK_WIDTH * be32_to_cpu(*id);
rg->chip.ngpio = MTK_BANK_WIDTH;
rg->chip.direction_input = mediatek_gpio_direction_input;
rg->chip.direction_output = mediatek_gpio_direction_output;
rg->chip.get_direction = mediatek_gpio_get_direction;
rg->chip.get = mediatek_gpio_get;
rg->chip.set = mediatek_gpio_set;
if (gpio_data->gpio_irq_domain)
rg->chip.to_irq = mediatek_gpio_to_irq;
rg->bank = be32_to_cpu(*id);
ret = devm_gpiochip_add_data(&pdev->dev, &rg->chip, gpio_data);
dat = gpio->gpio_membase + GPIO_REG_DATA + (rg->bank * GPIO_BANK_WIDE);
set = gpio->gpio_membase + GPIO_REG_DSET + (rg->bank * GPIO_BANK_WIDE);
ctrl = gpio->gpio_membase + GPIO_REG_DCLR + (rg->bank * GPIO_BANK_WIDE);
diro = gpio->gpio_membase + GPIO_REG_CTRL + (rg->bank * GPIO_BANK_WIDE);
ret = bgpio_init(&rg->chip, &pdev->dev, 4,
dat, set, ctrl, diro, NULL, 0);
if (ret) {
dev_err(&pdev->dev, "bgpio_init() failed\n");
return ret;
}
if (gpio->gpio_irq_domain)
rg->chip.to_irq = mediatek_gpio_to_irq;
ret = devm_gpiochip_add_data(&pdev->dev, &rg->chip, gpio);
if (ret < 0) {
dev_err(&pdev->dev, "Could not register gpio %d, ret=%d\n",
rg->chip.ngpio, ret);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment