rtlwifi: rtl8723{be,ae}: Remove CamelCase variables

If a macro is in CamelCase, it it converted to upper case. Variables
and routine names are converted to lower case.
Signed-off-by: Larry Finger <Larry.Finger@lwfinger.net>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/realtek/rtlwifi/rtl8723ae/def.h

@@ -94,7 +94,7 @@
 #define IS_VENDOR_8723A_B_CUT(version)	((IS_8723_SERIES(version))\
 		? ((GET_CVID_CUT_VERSION(version) == \
 		B_CUT_VERSION) ? true : false) : false)
-#define IS_81xxC_VENDOR_UMC_B_CUT(version)	((IS_CHIP_VENDOR_UMC(version))\
+#define IS_81XXC_VENDOR_UMC_B_CUT(version)	((IS_CHIP_VENDOR_UMC(version))\
 		? ((GET_CVID_CUT_VERSION(version) == \
 		B_CUT_VERSION) ? true : false) : false)
 

drivers/net/wireless/realtek/rtlwifi/rtl8723ae/hw.c

@@ -676,7 +676,7 @@ static bool _rtl8712e_init_mac(struct ieee80211_hw *hw)
 
 	/* HW Power on sequence */
 	if (!rtl_hal_pwrseqcmdparsing(rtlpriv, PWR_CUT_ALL_MSK, PWR_FAB_ALL_MSK,
-		PWR_INTF_PCI_MSK, Rtl8723_NIC_ENABLE_FLOW))
+		PWR_INTF_PCI_MSK, RTL8723_NIC_ENABLE_FLOW))
 		return false;
 
 	bytetmp = rtl_read_byte(rtlpriv, REG_PCIE_CTRL_REG+2);
@@ -966,7 +966,7 @@ int rtl8723e_hw_init(struct ieee80211_hw *hw)
 	if (IS_VENDOR_UMC_A_CUT(rtlhal->version)) {
 		rtl_set_rfreg(hw, RF90_PATH_A, RF_RX_G1, MASKDWORD, 0x30255);
 		rtl_set_rfreg(hw, RF90_PATH_A, RF_RX_G2, MASKDWORD, 0x50a00);
-	} else if (IS_81xxC_VENDOR_UMC_B_CUT(rtlhal->version)) {
+	} else if (IS_81XXC_VENDOR_UMC_B_CUT(rtlhal->version)) {
 		rtl_set_rfreg(hw, RF90_PATH_A, 0x0C, MASKDWORD, 0x894AE);
 		rtl_set_rfreg(hw, RF90_PATH_A, 0x0A, MASKDWORD, 0x1AF31);
 		rtl_set_rfreg(hw, RF90_PATH_A, RF_IPA, MASKDWORD, 0x8F425);
@@ -1262,7 +1262,7 @@ static void _rtl8723e_poweroff_adapter(struct ieee80211_hw *hw)
 	/* Combo (PCIe + USB) Card and PCIe-MF Card */
 	/* 1. Run LPS WL RFOFF flow */
 	rtl_hal_pwrseqcmdparsing(rtlpriv, PWR_CUT_ALL_MSK, PWR_FAB_ALL_MSK,
-				 PWR_INTF_PCI_MSK, Rtl8723_NIC_LPS_ENTER_FLOW);
+				 PWR_INTF_PCI_MSK, RTL8723_NIC_LPS_ENTER_FLOW);
 
 	/* 2. 0x1F[7:0] = 0 */
 	/* turn off RF */
@@ -1282,7 +1282,7 @@ static void _rtl8723e_poweroff_adapter(struct ieee80211_hw *hw)
 
 	/* HW card disable configuration. */
 	rtl_hal_pwrseqcmdparsing(rtlpriv, PWR_CUT_ALL_MSK, PWR_FAB_ALL_MSK,
-		PWR_INTF_PCI_MSK, Rtl8723_NIC_DISABLE_FLOW);
+		PWR_INTF_PCI_MSK, RTL8723_NIC_DISABLE_FLOW);
 
 	/* Reset MCU IO Wrapper */
 	u1b_tmp = rtl_read_byte(rtlpriv, REG_RSV_CTRL + 1);

drivers/net/wireless/realtek/rtlwifi/rtl8723ae/phy.c

@@ -883,7 +883,7 @@ static void _rtl8723e_phy_sw_rf_seting(struct ieee80211_hw *hw, u8 channel)
 	struct rtl_phy *rtlphy = &rtlpriv->phy;
 	struct rtl_hal *rtlhal = rtl_hal(rtl_priv(hw));
 
-	if (IS_81xxC_VENDOR_UMC_B_CUT(rtlhal->version)) {
+	if (IS_81XXC_VENDOR_UMC_B_CUT(rtlhal->version)) {
 		if (channel == 6 && rtlphy->current_chan_bw ==
 				HT_CHANNEL_WIDTH_20)
 			rtl_set_rfreg(hw, RF90_PATH_A, RF_RX_G1,

drivers/net/wireless/realtek/rtlwifi/rtl8723ae/phy.h

@@ -26,7 +26,7 @@
 #define MAX_STALL_TIME				50
 #define ANTENNADIVERSITYVALUE			0x80
 #define MAX_TXPWR_IDX_NMODE_92S			63
-#define Reset_Cnt_Limit				3
+#define reset_cnt_limit				3
 
 #define IQK_ADDA_REG_NUM			16
 #define IQK_MAC_REG_NUM				4

drivers/net/wireless/realtek/rtlwifi/rtl8723ae/pwrseq.h

@@ -305,14 +305,14 @@ extern struct wlan_pwr_cfg rtl8723A_leave_lps_flow
 		[RTL8723A_TRANS_LPS_TO_ACT_STEPS + RTL8723A_TRANS_END_STEPS];
 
 /* RTL8723 Power Configuration CMDs for PCIe interface */
-#define Rtl8723_NIC_PWR_ON_FLOW		rtl8723A_power_on_flow
-#define Rtl8723_NIC_RF_OFF_FLOW		rtl8723A_radio_off_flow
-#define Rtl8723_NIC_DISABLE_FLOW	rtl8723A_card_disable_flow
-#define Rtl8723_NIC_ENABLE_FLOW		rtl8723A_card_enable_flow
-#define Rtl8723_NIC_SUSPEND_FLOW	rtl8723A_suspend_flow
-#define Rtl8723_NIC_RESUME_FLOW		rtl8723A_resume_flow
-#define Rtl8723_NIC_PDN_FLOW		rtl8723A_hwpdn_flow
-#define Rtl8723_NIC_LPS_ENTER_FLOW	rtl8723A_enter_lps_flow
-#define Rtl8723_NIC_LPS_LEAVE_FLOW	rtl8723A_leave_lps_flow
+#define RTL8723_NIC_PWR_ON_FLOW		rtl8723A_power_on_flow
+#define RTL8723_NIC_RF_OFF_FLOW		rtl8723A_radio_off_flow
+#define RTL8723_NIC_DISABLE_FLOW	rtl8723A_card_disable_flow
+#define RTL8723_NIC_ENABLE_FLOW		rtl8723A_card_enable_flow
+#define RTL8723_NIC_SUSPEND_FLOW	rtl8723A_suspend_flow
+#define RTL8723_NIC_RESUME_FLOW		rtl8723A_resume_flow
+#define RTL8723_NIC_PDN_FLOW		rtl8723A_hwpdn_flow
+#define RTL8723_NIC_LPS_ENTER_FLOW	rtl8723A_enter_lps_flow
+#define RTL8723_NIC_LPS_LEAVE_FLOW	rtl8723A_leave_lps_flow
 
 #endif

drivers/net/wireless/realtek/rtlwifi/rtl8723ae/sw.c

@@ -153,7 +153,7 @@ int rtl8723e_init_sw_vars(struct ieee80211_hw *hw)
 		return 1;
 	}
 
-	if (IS_81xxC_VENDOR_UMC_B_CUT(rtlhal->version))
+	if (IS_81XXC_VENDOR_UMC_B_CUT(rtlhal->version))
 		fw_name = "rtlwifi/rtl8723fw_B.bin";
 
 	rtlpriv->max_fw_size = 0x6000;

drivers/net/wireless/realtek/rtlwifi/rtl8723be/hw.c

@@ -297,12 +297,12 @@ void rtl8723be_get_hw_reg(struct ieee80211_hw *hw, u8 variable, u8 *val)
 		*((enum rf_pwrstate *)(val)) = ppsc->rfpwr_state;
 		break;
 	case HW_VAR_FWLPS_RF_ON:{
-		enum rf_pwrstate rfState;
+		enum rf_pwrstate rfstate;
 		u32 val_rcr;
 
 		rtlpriv->cfg->ops->get_hw_reg(hw, HW_VAR_RF_STATE,
-					      (u8 *)(&rfState));
-		if (rfState == ERFOFF) {
+					      (u8 *)(&rfstate));
+		if (rfstate == ERFOFF) {
 			*((bool *)(val)) = true;
 		} else {
 			val_rcr = rtl_read_dword(rtlpriv, REG_RCR);
@@ -742,10 +742,10 @@ static bool _rtl8723be_llt_table_init(struct ieee80211_hw *hw)
 	struct rtl_priv *rtlpriv = rtl_priv(hw);
 	unsigned short i;
 	u8 txpktbuf_bndy;
-	u8 maxPage;
+	u8 maxpage;
 	bool status;
 
-	maxPage = 255;
+	maxpage = 255;
 	txpktbuf_bndy = 245;
 
 	rtl_write_dword(rtlpriv, REG_TRXFF_BNDY,
@@ -770,13 +770,13 @@ static bool _rtl8723be_llt_table_init(struct ieee80211_hw *hw)
 	if (!status)
 		return status;
 
-	for (i = txpktbuf_bndy; i < maxPage; i++) {
+	for (i = txpktbuf_bndy; i < maxpage; i++) {
 		status = _rtl8723be_llt_write(hw, i, (i + 1));
 		if (!status)
 			return status;
 	}
 
-	status = _rtl8723be_llt_write(hw, maxPage, txpktbuf_bndy);
+	status = _rtl8723be_llt_write(hw, maxpage, txpktbuf_bndy);
 	if (!status)
 		return status;