Commit 93afa752 authored by Andrew Victor's avatar Andrew Victor Committed by Russell King

[ARM] 4355/2: AT91: SAM9260-EK and SAM9263-EK board updates

Various small changes for the Atmel AT91SAM9260-EK and AT91SAM9263-EK
boards.

SAM9260-EK:
  - Register I2C device.

SAM9263-EK:
  - Add platform_data and register MACB device.
    (Patch by Nicolas Ferre)
  - Add platform_data and register AC97 device.
    (Patch by Nicolas Ferre)
  - Register I2C device.
Signed-off-by: default avatarAndrew Victor <andrew@sanpeople.com>
Signed-off-by: default avatarRussell King <rmk+kernel@arm.linux.org.uk>
parent 03abeac0
......@@ -104,9 +104,9 @@ static struct spi_board_info ek_spi_devices[] = {
},
#endif
#endif
#if defined(CONFIG_SND_AT73C213)
#if defined(CONFIG_SND_AT73C213) || defined(CONFIG_SND_AT73C213_MODULE)
{ /* AT73C213 DAC */
.modalias = "snd_at73c213",
.modalias = "at73c213",
.chip_select = 0,
.max_speed_hz = 10 * 1000 * 1000,
.bus_num = 1,
......@@ -188,6 +188,8 @@ static void __init ek_board_init(void)
at91_add_device_eth(&ek_macb_data);
/* MMC */
at91_add_device_mmc(0, &ek_mmc_data);
/* I2C */
at91_add_device_i2c();
}
MACHINE_START(AT91SAM9260EK, "Atmel AT91SAM9260-EK")
......
......@@ -156,6 +156,14 @@ static struct at91_mmc_data __initdata ek_mmc_data = {
};
/*
* MACB Ethernet device
*/
static struct at91_eth_data __initdata ek_macb_data = {
.is_rmii = 1,
};
/*
* NAND flash
*/
......@@ -193,6 +201,14 @@ static struct at91_nand_data __initdata ek_nand_data = {
};
/*
* AC97
*/
static struct atmel_ac97_data ek_ac97_data = {
.reset_pin = AT91_PIN_PA13,
};
static void __init ek_board_init(void)
{
/* Serial */
......@@ -208,8 +224,14 @@ static void __init ek_board_init(void)
ek_add_device_ts();
/* MMC */
at91_add_device_mmc(1, &ek_mmc_data);
/* Ethernet */
at91_add_device_eth(&ek_macb_data);
/* NAND */
at91_add_device_nand(&ek_nand_data);
/* I2C */
at91_add_device_i2c();
/* AC97 */
at91_add_device_ac97(&ek_ac97_data);
}
MACHINE_START(AT91SAM9263EK, "Atmel AT91SAM9263-EK")
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment