ARM: set BE8 if LE in head code

If we are booting in LE and compiled for BE8, then add code to
set the state to bE8. Since the instruction stream is always LE,
we do not need to do anything special to the instruction.

Also ensure that the secondary processors are started in the same mode.

Note, we do add about 20 bytes to the kernel image, but it seems easier
to do this than adding another configuration to change.
Signed-off-by: Ben Dooks <ben.dooks@codethink.co.uk>
Reviewed-by: Dave Martin <Dave.Martin@arm.com>
Tested-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>

arch/arm/boot/compressed/head.S

@@ -135,6 +135,7 @@ start:
 		.word	_edata			@ zImage end address
  THUMB(		.thumb			)
 1:
+ ARM_BE8(	setend	be )			@ go BE8 if compiled for BE8
 		mrs	r9, cpsr
 #ifdef CONFIG_ARM_VIRT_EXT
 		bl	__hyp_stub_install	@ get into SVC mode, reversibly

arch/arm/kernel/head.S

@@ -77,6 +77,7 @@
 
 	__HEAD
 ENTRY(stext)
+ ARM_BE8(setend	be )			@ ensure we are in BE8 mode
 
  THUMB(	adr	r9, BSYM(1f)	)	@ Kernel is always entered in ARM.
  THUMB(	bx	r9		)	@ If this is a Thumb-2 kernel,
@@ -352,6 +353,9 @@ ENTRY(secondary_startup)
 	 * the processor type - there is no need to check the machine type
 	 * as it has already been validated by the primary processor.
 	 */
+
+ ARM_BE8(setend	be)				@ ensure we are in BE8 mode
+
 #ifdef CONFIG_ARM_VIRT_EXT
 	bl	__hyp_stub_install_secondary
 #endif

arch/arm/kernel/sleep.S

@@ -130,6 +130,7 @@ ENDPROC(cpu_resume_after_mmu)
 	.data
 	.align
 ENTRY(cpu_resume)
+ARM_BE8(setend be)			@ ensure we are in BE mode
 	mov	r1, #0
 	ALT_SMP(mrc p15, 0, r0, c0, c0, 5)
 	ALT_UP_B(1f)