Commit a10e2f2f authored by Vasanthakumar Thiagarajan's avatar Vasanthakumar Thiagarajan Committed by Kalle Valo

ath6kl: Add a module parameter to enable uart debug

To enable firmware debug messages through uart interface,

modprobe ath6kl_sdio uart_debug=1.
Signed-off-by: default avatarVasanthakumar Thiagarajan <vthiagar@qca.qualcomm.com>
Signed-off-by: default avatarKalle Valo <kvalo@qca.qualcomm.com>
parent 351de283
...@@ -28,10 +28,12 @@ ...@@ -28,10 +28,12 @@
unsigned int debug_mask; unsigned int debug_mask;
static unsigned int testmode; static unsigned int testmode;
static bool suspend_cutpower; static bool suspend_cutpower;
static unsigned int uart_debug;
module_param(debug_mask, uint, 0644); module_param(debug_mask, uint, 0644);
module_param(testmode, uint, 0644); module_param(testmode, uint, 0644);
module_param(suspend_cutpower, bool, 0444); module_param(suspend_cutpower, bool, 0444);
module_param(uart_debug, uint, 0644);
static const struct ath6kl_hw hw_list[] = { static const struct ath6kl_hw hw_list[] = {
{ {
...@@ -464,6 +466,13 @@ int ath6kl_configure_target(struct ath6kl *ar) ...@@ -464,6 +466,13 @@ int ath6kl_configure_target(struct ath6kl *ar)
u8 fw_iftype, fw_mode = 0, fw_submode = 0; u8 fw_iftype, fw_mode = 0, fw_submode = 0;
int i, status; int i, status;
param = uart_debug;
if (ath6kl_bmi_write(ar, ath6kl_get_hi_item_addr(ar,
HI_ITEM(hi_serial_enable)), (u8 *)&param, 4)) {
ath6kl_err("bmi_write_memory for uart debug failed\n");
return -EIO;
}
/* /*
* Note: Even though the firmware interface type is * Note: Even though the firmware interface type is
* chosen as BSS_STA for all three interfaces, can * chosen as BSS_STA for all three interfaces, can
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment