Merge branch 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux

Pull i2c fixes from Wolfram Sang:
 "Mostly driver bugfixes, but also a few cleanups which are nice to have
  out of the way"

* 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
  i2c: rk3x: Restore clock settings at resume time
  i2c: Spelling s/acknowedge/acknowledge/
  i2c: designware: save the preset value of DW_IC_SDA_HOLD
  Documentation: i2c: slave-interface: add note for driver development
  i2c: mux: demux-pinctrl: run properly with multiple instances
  i2c: bcm-kona: fix inconsistent indenting
  i2c: rcar: use proper device with dma_mapping_error
  i2c: sh_mobile: use proper device with dma_mapping_error
  i2c: mux: demux-pinctrl: invalidate properly when switching fails

Documentation/i2c/slave-interface

@@ -145,6 +145,11 @@ If you want to add slave support to the bus driver:
 
 * Catch the slave interrupts and send appropriate i2c_slave_events to the backend.
 
+Note that most hardware supports being master _and_ slave on the same bus. So,
+if you extend a bus driver, please make sure that the driver supports that as
+well. In almost all cases, slave support does not need to disable the master
+functionality.
+
 Check the i2c-rcar driver as an example.
 
 

drivers/i2c/busses/i2c-cadence.c

@@ -767,7 +767,7 @@ static int cdns_i2c_setclk(unsigned long clk_in, struct cdns_i2c *id)
  * depending on the scaling direction.
  *
  * Return:	NOTIFY_STOP if the rate change should be aborted, NOTIFY_OK
- *		to acknowedge the change, NOTIFY_DONE if the notification is
+ *		to acknowledge the change, NOTIFY_DONE if the notification is
  *		considered irrelevant.
  */
 static int cdns_i2c_clk_notifier_cb(struct notifier_block *nb, unsigned long

drivers/i2c/busses/i2c-designware-core.c

@@ -367,13 +367,17 @@ int i2c_dw_init(struct dw_i2c_dev *dev)
 	dev_dbg(dev->dev, "Fast-mode HCNT:LCNT = %d:%d\n", hcnt, lcnt);
 
 	/* Configure SDA Hold Time if required */
-	if (dev->sda_hold_time) {
 	reg = dw_readl(dev, DW_IC_COMP_VERSION);
-		if (reg >= DW_IC_SDA_HOLD_MIN_VERS)
+	if (reg >= DW_IC_SDA_HOLD_MIN_VERS) {
+		if (dev->sda_hold_time) {
 			dw_writel(dev, dev->sda_hold_time, DW_IC_SDA_HOLD);
-		else
+		} else {
+			/* Keep previous hold time setting if no one set it */
+			dev->sda_hold_time = dw_readl(dev, DW_IC_SDA_HOLD);
+		}
+	} else {
 		dev_warn(dev->dev,
-				"Hardware too old to adjust SDA hold time.");
+			"Hardware too old to adjust SDA hold time.\n");
 	}
 
 	/* Configure Tx/Rx FIFO threshold levels */

drivers/i2c/busses/i2c-rcar.c

@@ -378,7 +378,7 @@ static void rcar_i2c_dma(struct rcar_i2c_priv *priv)
 	}
 
 	dma_addr = dma_map_single(chan->device->dev, buf, len, dir);
-	if (dma_mapping_error(dev, dma_addr)) {
+	if (dma_mapping_error(chan->device->dev, dma_addr)) {
 		dev_dbg(dev, "dma map failed, using PIO\n");
 		return;
 	}

drivers/i2c/busses/i2c-rk3x.c

@@ -918,7 +918,7 @@ static void rk3x_i2c_adapt_div(struct rk3x_i2c *i2c, unsigned long clk_rate)
  * Code adapted from i2c-cadence.c.
  *
  * Return:	NOTIFY_STOP if the rate change should be aborted, NOTIFY_OK
- *		to acknowedge the change, NOTIFY_DONE if the notification is
+ *		to acknowledge the change, NOTIFY_DONE if the notification is
  *		considered irrelevant.
  */
 static int rk3x_i2c_clk_notifier_cb(struct notifier_block *nb, unsigned long
@@ -1111,6 +1111,15 @@ static int rk3x_i2c_xfer(struct i2c_adapter *adap,
 	return ret < 0 ? ret : num;
 }
 
+static __maybe_unused int rk3x_i2c_resume(struct device *dev)
+{
+	struct rk3x_i2c *i2c = dev_get_drvdata(dev);
+
+	rk3x_i2c_adapt_div(i2c, clk_get_rate(i2c->clk));
+
+	return 0;
+}
+
 static u32 rk3x_i2c_func(struct i2c_adapter *adap)
 {
 	return I2C_FUNC_I2C | I2C_FUNC_SMBUS_EMUL | I2C_FUNC_PROTOCOL_MANGLING;
@@ -1334,12 +1343,15 @@ static int rk3x_i2c_remove(struct platform_device *pdev)
 	return 0;
 }
 
+static SIMPLE_DEV_PM_OPS(rk3x_i2c_pm_ops, NULL, rk3x_i2c_resume);
+
 static struct platform_driver rk3x_i2c_driver = {
 	.probe   = rk3x_i2c_probe,
 	.remove  = rk3x_i2c_remove,
 	.driver  = {
 		.name  = "rk3x-i2c",
 		.of_match_table = rk3x_i2c_match,
+		.pm = &rk3x_i2c_pm_ops,
 	},
 };
 

drivers/i2c/busses/i2c-sh_mobile.c

@@ -610,7 +610,7 @@ static void sh_mobile_i2c_xfer_dma(struct sh_mobile_i2c_data *pd)
 		return;
 
 	dma_addr = dma_map_single(chan->device->dev, pd->msg->buf, pd->msg->len, dir);
-	if (dma_mapping_error(pd->dev, dma_addr)) {
+	if (dma_mapping_error(chan->device->dev, dma_addr)) {
 		dev_dbg(pd->dev, "dma map failed, using PIO\n");
 		return;
 	}

drivers/i2c/muxes/i2c-demux-pinctrl.c

@@ -37,8 +37,6 @@ struct i2c_demux_pinctrl_priv {
 	struct i2c_demux_pinctrl_chan chan[];
 };
 
-static struct property status_okay = { .name = "status", .length = 3, .value = "ok" };
-
 static int i2c_demux_master_xfer(struct i2c_adapter *adap, struct i2c_msg msgs[], int num)
 {
 	struct i2c_demux_pinctrl_priv *priv = adap->algo_data;
@@ -107,6 +105,7 @@ static int i2c_demux_activate_master(struct i2c_demux_pinctrl_priv *priv, u32 ne
 	of_changeset_revert(&priv->chan[new_chan].chgset);
  err:
 	dev_err(priv->dev, "failed to setup demux-adapter %d (%d)\n", new_chan, ret);
+	priv->cur_chan = -EINVAL;
 	return ret;
 }
 
@@ -192,6 +191,7 @@ static int i2c_demux_pinctrl_probe(struct platform_device *pdev)
 {
 	struct device_node *np = pdev->dev.of_node;
 	struct i2c_demux_pinctrl_priv *priv;
+	struct property *props;
 	int num_chan, i, j, err;
 
 	num_chan = of_count_phandle_with_args(np, "i2c-parent", NULL);
@@ -202,7 +202,10 @@ static int i2c_demux_pinctrl_probe(struct platform_device *pdev)
 
 	priv = devm_kzalloc(&pdev->dev, sizeof(*priv)
 			   + num_chan * sizeof(struct i2c_demux_pinctrl_chan), GFP_KERNEL);
-	if (!priv)
+
+	props = devm_kcalloc(&pdev->dev, num_chan, sizeof(*props), GFP_KERNEL);
+
+	if (!priv || !props)
 		return -ENOMEM;
 
 	err = of_property_read_string(np, "i2c-bus-name", &priv->bus_name);
@@ -220,8 +223,12 @@ static int i2c_demux_pinctrl_probe(struct platform_device *pdev)
 		}
 		priv->chan[i].parent_np = adap_np;
 
+		props[i].name = devm_kstrdup(&pdev->dev, "status", GFP_KERNEL);
+		props[i].value = devm_kstrdup(&pdev->dev, "ok", GFP_KERNEL);
+		props[i].length = 3;
+
 		of_changeset_init(&priv->chan[i].chgset);
-		of_changeset_update_property(&priv->chan[i].chgset, adap_np, &status_okay);
+		of_changeset_update_property(&priv->chan[i].chgset, adap_np, &props[i]);
 	}
 
 	priv->num_chan = num_chan;