Commit b9beb517 authored by Douglas Gilbert's avatar Douglas Gilbert Committed by Greg Kroah-Hartman

ses: requesting a fault indication

commit 2a350cab upstream.

Noticed that when the sysfs interface of the SCSI SES
driver was used to request a fault indication the LED
flashed but the buzzer didn't sound. So it was doing
what REQUEST IDENT (locate) should do.

Changelog:
   - fix the setting of REQUEST FAULT for the device slot
     and array device slot elements in the enclosure control
     diagnostic page
   - note the potentially defective code that reads the
     FAULT SENSED and FAULT REQUESTED bits from the enclosure
     status diagnostic page

The attached patch is against git/scsi-misc-2.6
Signed-off-by: default avatarDouglas Gilbert <dgilbert@interlog.com>
Signed-off-by: default avatarJames Bottomley <JBottomley@Parallels.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@suse.de>
parent 645b2cf1
...@@ -160,6 +160,10 @@ static unsigned char *ses_get_page2_descriptor(struct enclosure_device *edev, ...@@ -160,6 +160,10 @@ static unsigned char *ses_get_page2_descriptor(struct enclosure_device *edev,
return NULL; return NULL;
} }
/* For device slot and array device slot elements, byte 3 bit 6
* is "fault sensed" while byte 3 bit 5 is "fault reqstd". As this
* code stands these bits are shifted 4 positions right so in
* sysfs they will appear as bits 2 and 1 respectively. Strange. */
static void ses_get_fault(struct enclosure_device *edev, static void ses_get_fault(struct enclosure_device *edev,
struct enclosure_component *ecomp) struct enclosure_component *ecomp)
{ {
...@@ -181,7 +185,7 @@ static int ses_set_fault(struct enclosure_device *edev, ...@@ -181,7 +185,7 @@ static int ses_set_fault(struct enclosure_device *edev,
/* zero is disabled */ /* zero is disabled */
break; break;
case ENCLOSURE_SETTING_ENABLED: case ENCLOSURE_SETTING_ENABLED:
desc[2] = 0x02; desc[3] = 0x20;
break; break;
default: default:
/* SES doesn't do the SGPIO blink settings */ /* SES doesn't do the SGPIO blink settings */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment