[PATCH] au1100fb: Fix startup sequence

- fix up the start up sequence.

This new sequence allow you to correctly enable the LCD controller
even if the bootloader has already did it.

- fix up a wrong indentation issue.
Signed-off-by: Rodolfo Giometti <giometti@linux.it>
Signed-off-by: Antonino Daplas <adaplas@pol.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

drivers/video/au1100fb.c

@@ -169,16 +169,11 @@ int au1100fb_setmode(struct au1100fb_device *fbdev)
 
 	/* Determine BPP mode and format */
 	fbdev->regs->lcd_control = fbdev->panel->control_base;
-
-	fbdev->regs->lcd_intenable = 0;
-	fbdev->regs->lcd_intstatus = 0;
-
 	fbdev->regs->lcd_horztiming = fbdev->panel->horztiming;
-
 	fbdev->regs->lcd_verttiming = fbdev->panel->verttiming;
-
 	fbdev->regs->lcd_clkcontrol = fbdev->panel->clkcontrol_base;
-
+	fbdev->regs->lcd_intenable = 0;
+	fbdev->regs->lcd_intstatus = 0;
 	fbdev->regs->lcd_dmaaddr0 = LCD_DMA_SA_N(fbdev->fb_phys);
 
 	if (panel_is_dual(fbdev->panel)) {
@@ -207,6 +202,8 @@ int au1100fb_setmode(struct au1100fb_device *fbdev)
 
 	/* Resume controller */
 	fbdev->regs->lcd_control |= LCD_CONTROL_GO;
+	mdelay(10);
+	au1100fb_fb_blank(VESA_NO_BLANKING, info);
 
 	return 0;
 }