Commit be3f39c8 authored by Roger Quadros's avatar Roger Quadros Committed by Tony Lindgren

ARM: dts: am437x: Fix NAND device nodes

Add compatible id, GPMC register resource and interrupt
resource to NAND controller nodes.

The GPMC node will provide an interrupt controller for the
NAND IRQs.
Signed-off-by: default avatarRoger Quadros <rogerq@ti.com>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent 79c08261
......@@ -893,6 +893,8 @@ gpmc: gpmc@50000000 {
gpmc,num-waitpins = <2>;
#address-cells = <2>;
#size-cells = <1>;
interrupt-controller;
#interrupt-cells = <2>;
status = "disabled";
};
......
......@@ -146,7 +146,11 @@ &gpmc {
pinctrl-0 = <&nand_flash_x8>;
ranges = <0 0 0x08000000 0x1000000>;
nand@0,0 {
reg = <0 0 0>;
compatible = "ti,omap2-nand";
reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
interrupt-parent = <&gpmc>;
interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
<1 IRQ_TYPE_NONE>; /* termcount */
ti,nand-ecc-opt = "bch8";
ti,elm-id = <&elm>;
......
......@@ -812,9 +812,13 @@ &gpmc {
status = "okay";
pinctrl-names = "default";
pinctrl-0 = <&nand_flash_x8>;
ranges = <0 0 0 0x01000000>; /* minimum GPMC partition = 16MB */
ranges = <0 0 0x08000000 0x01000000>; /* CS0 space. Min partition = 16MB */
nand@0,0 {
compatible = "ti,omap2-nand";
reg = <0 0 4>; /* device IO registers */
interrupt-parent = <&gpmc>;
interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
<1 IRQ_TYPE_NONE>; /* termcount */
ti,nand-ecc-opt = "bch16";
ti,elm-id = <&elm>;
nand-bus-width = <8>;
......
......@@ -561,9 +561,13 @@ &gpmc {
status = "okay"; /* Disable QSPI when enabling GPMC (NAND) */
pinctrl-names = "default";
pinctrl-0 = <&nand_flash_x8>;
ranges = <0 0 0x08000000 0x1000000>; /* CS0: 16MB for NAND */
ranges = <0 0 0x08000000 0x01000000>; /* CS0 space. Min partition = 16MB */
nand@0,0 {
compatible = "ti,omap2-nand";
reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
interrupt-parent = <&gpmc>;
interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
<1 IRQ_TYPE_NONE>; /* termcount */
ti,nand-ecc-opt = "bch16";
ti,elm-id = <&elm>;
nand-bus-width = <8>;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment