media: staging: rkisp1: cap: support uv swap only for semiplanar formats

The register RKISP1_CIF_MI_XTD_FORMAT_CTRL is relevant only
for semiplanar formats, therefore the uv swap can be supported
through this register only for semiplanar formats.
Signed-off-by: Dafna Hirschfeld <dafna.hirschfeld@collabora.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>

drivers/staging/media/rkisp1/rkisp1-capture.c

@@ -383,12 +383,16 @@ static void rkisp1_mp_config(struct rkisp1_capture *cap)
 		     cap->config->mi.cr_size_init);
 
 	rkisp1_irq_frame_end_enable(cap);
+
+	/* set uv swapping for semiplanar formats */
+	if (cap->pix.info->comp_planes == 2) {
 		reg = rkisp1_read(rkisp1, RKISP1_CIF_MI_XTD_FORMAT_CTRL);
 		if (cap->pix.cfg->uv_swap)
 			reg |= RKISP1_CIF_MI_XTD_FMT_CTRL_MP_CB_CR_SWAP;
 		else
 			reg &= ~RKISP1_CIF_MI_XTD_FMT_CTRL_MP_CB_CR_SWAP;
 		rkisp1_write(rkisp1, reg, RKISP1_CIF_MI_XTD_FORMAT_CTRL);
+	}
 
 	rkisp1_mi_config_ctrl(cap);
 
@@ -421,12 +425,15 @@ static void rkisp1_sp_config(struct rkisp1_capture *cap)
 
 	rkisp1_irq_frame_end_enable(cap);
 
+	/* set uv swapping for semiplanar formats */
+	if (cap->pix.info->comp_planes == 2) {
 		reg = rkisp1_read(rkisp1, RKISP1_CIF_MI_XTD_FORMAT_CTRL);
 		if (cap->pix.cfg->uv_swap)
 			reg |= RKISP1_CIF_MI_XTD_FMT_CTRL_SP_CB_CR_SWAP;
 		else
 			reg &= ~RKISP1_CIF_MI_XTD_FMT_CTRL_SP_CB_CR_SWAP;
 		rkisp1_write(rkisp1, reg, RKISP1_CIF_MI_XTD_FORMAT_CTRL);
+	}
 
 	rkisp1_mi_config_ctrl(cap);