Merge branch 'macb-support-the-2-deep-Tx-queue-on-at91'

Willy Tarreau says:

====================
macb: support the 2-deep Tx queue on at91

while running some tests on my Breadbee board, I noticed poor network
Tx performance. I had a look at the driver (macb, at91ether variant)
and noticed that at91ether_start_xmit() immediately stops the queue
after sending a frame and waits for the interrupt to restart the queue,
causing a dead time after each packet is sent.

The AT91RM9200 datasheet states that the controller supports two frames,
one being sent and the other one being queued, so I performed minimal
changes to support this. The transmit performance on my board has
increased by 50% on medium-sized packets (HTTP traffic), and with large
packets I can now reach line rate.

Since this driver is shared by various platforms, I tried my best to
isolate and limit the changes as much as possible and I think it's pretty
reasonable as-is. I've run extensive tests and couldn't meet any
unexpected situation (no stall, overflow nor lockup).

There are 3 patches in this series. The first one adds the missing
interrupt flag for RM9200 (TBRE, indicating the tx buffer is willing
to take a new packet). The second one replaces the single skb with a
2-array and uses only index 0. It does no other change, this is just
to prepare the code for the third one. The third one implements the
queue. Packets are added at the tail of the queue, the queue is
stopped at 2 packets and the interrupt releases 0, 1 or 2 depending
on what the transmit status register reports.
====================
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

drivers/net/ethernet/cadence/macb.h

@@ -366,6 +366,8 @@
 #define MACB_ISR_RLE_SIZE	1
 #define MACB_TXERR_OFFSET	6 /* EN TX frame corrupt from error interrupt */
 #define MACB_TXERR_SIZE		1
+#define MACB_RM9200_TBRE_OFFSET	6 /* EN may send new frame interrupt (RM9200) */
+#define MACB_RM9200_TBRE_SIZE	1
 #define MACB_TCOMP_OFFSET	7 /* Enable transmit complete interrupt */
 #define MACB_TCOMP_SIZE		1
 #define MACB_ISR_LINK_OFFSET	9 /* Enable link change interrupt */
@@ -1205,10 +1207,10 @@ struct macb {
 
 	phy_interface_t		phy_interface;
 
-	/* AT91RM9200 transmit */
-	struct sk_buff *skb;			/* holds skb until xmit interrupt completes */
-	dma_addr_t skb_physaddr;		/* phys addr from pci_map_single */
-	int skb_length;				/* saved skb length for pci_unmap_single */
+	/* AT91RM9200 transmit queue (1 on wire + 1 queued) */
+	struct macb_tx_skb	rm9200_txq[2];
+	unsigned int		rm9200_tx_tail;
+	unsigned int		rm9200_tx_len;
 	unsigned int		max_tx_length;
 
 	u64			ethtool_stats[GEM_STATS_LEN + QUEUE_STATS_LEN * MACB_MAX_QUEUES];

drivers/net/ethernet/cadence/macb_main.c

@@ -3908,6 +3908,7 @@ static int at91ether_start(struct macb *lp)
 			     MACB_BIT(ISR_TUND)	|
 			     MACB_BIT(ISR_RLE)	|
 			     MACB_BIT(TCOMP)	|
+			     MACB_BIT(RM9200_TBRE)	|
 			     MACB_BIT(ISR_ROVR)	|
 			     MACB_BIT(HRESP));
 
@@ -3924,6 +3925,7 @@ static void at91ether_stop(struct macb *lp)
 			     MACB_BIT(ISR_TUND)	|
 			     MACB_BIT(ISR_RLE)	|
 			     MACB_BIT(TCOMP)	|
+			     MACB_BIT(RM9200_TBRE)	|
 			     MACB_BIT(ISR_ROVR) |
 			     MACB_BIT(HRESP));
 
@@ -3993,24 +3995,34 @@ static netdev_tx_t at91ether_start_xmit(struct sk_buff *skb,
 					struct net_device *dev)
 {
 	struct macb *lp = netdev_priv(dev);
+	unsigned long flags;
 
-	if (macb_readl(lp, TSR) & MACB_BIT(RM9200_BNQ)) {
-		netif_stop_queue(dev);
+	if (lp->rm9200_tx_len < 2) {
+		int desc = lp->rm9200_tx_tail;
 
 		/* Store packet information (to free when Tx completed) */
-		lp->skb = skb;
-		lp->skb_length = skb->len;
-		lp->skb_physaddr = dma_map_single(&lp->pdev->dev, skb->data,
+		lp->rm9200_txq[desc].skb = skb;
+		lp->rm9200_txq[desc].size = skb->len;
+		lp->rm9200_txq[desc].mapping = dma_map_single(&lp->pdev->dev, skb->data,
 							      skb->len, DMA_TO_DEVICE);
-		if (dma_mapping_error(&lp->pdev->dev, lp->skb_physaddr)) {
+		if (dma_mapping_error(&lp->pdev->dev, lp->rm9200_txq[desc].mapping)) {
 			dev_kfree_skb_any(skb);
 			dev->stats.tx_dropped++;
 			netdev_err(dev, "%s: DMA mapping error\n", __func__);
 			return NETDEV_TX_OK;
 		}
 
+		spin_lock_irqsave(&lp->lock, flags);
+
+		lp->rm9200_tx_tail = (desc + 1) & 1;
+		lp->rm9200_tx_len++;
+		if (lp->rm9200_tx_len > 1)
+			netif_stop_queue(dev);
+
+		spin_unlock_irqrestore(&lp->lock, flags);
+
 		/* Set address of the data in the Transmit Address register */
-		macb_writel(lp, TAR, lp->skb_physaddr);
+		macb_writel(lp, TAR, lp->rm9200_txq[desc].mapping);
 		/* Set length of the packet in the Transmit Control register */
 		macb_writel(lp, TCR, skb->len);
 
@@ -4073,6 +4085,9 @@ static irqreturn_t at91ether_interrupt(int irq, void *dev_id)
 	struct net_device *dev = dev_id;
 	struct macb *lp = netdev_priv(dev);
 	u32 intstatus, ctl;
+	unsigned int desc;
+	unsigned int qlen;
+	u32 tsr;
 
 	/* MAC Interrupt Status register indicates what interrupts are pending.
 	 * It is automatically cleared once read.
@@ -4084,20 +4099,39 @@ static irqreturn_t at91ether_interrupt(int irq, void *dev_id)
 		at91ether_rx(dev);
 
 	/* Transmit complete */
-	if (intstatus & MACB_BIT(TCOMP)) {
+	if (intstatus & (MACB_BIT(TCOMP) | MACB_BIT(RM9200_TBRE))) {
 		/* The TCOM bit is set even if the transmission failed */
 		if (intstatus & (MACB_BIT(ISR_TUND) | MACB_BIT(ISR_RLE)))
 			dev->stats.tx_errors++;
 
-		if (lp->skb) {
-			dev_consume_skb_irq(lp->skb);
-			lp->skb = NULL;
-			dma_unmap_single(&lp->pdev->dev, lp->skb_physaddr,
-					 lp->skb_length, DMA_TO_DEVICE);
+		spin_lock(&lp->lock);
+
+		tsr = macb_readl(lp, TSR);
+
+		/* we have three possibilities here:
+		 *   - all pending packets transmitted (TGO, implies BNQ)
+		 *   - only first packet transmitted (!TGO && BNQ)
+		 *   - two frames pending (!TGO && !BNQ)
+		 * Note that TGO ("transmit go") is called "IDLE" on RM9200.
+		 */
+		qlen = (tsr & MACB_BIT(TGO)) ? 0 :
+			(tsr & MACB_BIT(RM9200_BNQ)) ? 1 : 2;
+
+		while (lp->rm9200_tx_len > qlen) {
+			desc = (lp->rm9200_tx_tail - lp->rm9200_tx_len) & 1;
+			dev_consume_skb_irq(lp->rm9200_txq[desc].skb);
+			lp->rm9200_txq[desc].skb = NULL;
+			dma_unmap_single(&lp->pdev->dev, lp->rm9200_txq[desc].mapping,
+					 lp->rm9200_txq[desc].size, DMA_TO_DEVICE);
 			dev->stats.tx_packets++;
-			dev->stats.tx_bytes += lp->skb_length;
+			dev->stats.tx_bytes += lp->rm9200_txq[desc].size;
+			lp->rm9200_tx_len--;
 		}
+
+		if (lp->rm9200_tx_len < 2 && netif_queue_stopped(dev))
 			netif_wake_queue(dev);
+
+		spin_unlock(&lp->lock);
 	}
 
 	/* Work-around for EMAC Errata section 41.3.1 */