i2c: Add SCCB support

SCCB is a serial communication bus developed by Omnivision. Its 2-wire
mode is very similar to SMBus byte data transactions, but requires the
controller to ignore the ACK bit and to insert a stop condition after
each message.

Add a device SCCB flag and a message stop flag to be passed to
controller drivers.

[JD: Kill rogue definition in go7007 driver.]
Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Jean Delvare <khali@linux-fr.org>

drivers/i2c/i2c-core.c

@@ -2122,7 +2122,7 @@ s32 i2c_smbus_xfer(struct i2c_adapter *adapter, u16 addr, unsigned short flags,
 	int try;
 	s32 res;
 
-	flags &= I2C_M_TEN | I2C_CLIENT_PEC;
+	flags &= I2C_M_TEN | I2C_CLIENT_PEC | I2C_CLIENT_SCCB;
 
 	if (adapter->algo->smbus_xfer) {
 		i2c_lock_adapter(adapter);

drivers/staging/media/go7007/wis-i2c.h

@@ -25,11 +25,6 @@
 #define	I2C_DRIVERID_WIS_TW2804		0xf0f6
 #define	I2C_DRIVERID_S2250		0xf0f7
 
-/* Flag to indicate that the client needs to be accessed with SCCB semantics */
-/* We re-use the I2C_M_TEN value so the flag passes through the masks in the
- * core I2C code.  Major kludge, but the I2C layer ain't exactly flexible. */
-#define	I2C_CLIENT_SCCB			0x10
-
 /* Definitions for new video decoder commands */
 
 struct video_decoder_resolution {

include/linux/i2c.h

@@ -425,6 +425,8 @@ void i2c_unlock_adapter(struct i2c_adapter *);
 #define I2C_CLIENT_TEN	0x10		/* we have a ten bit chip address */
 					/* Must equal I2C_M_TEN below */
 #define I2C_CLIENT_WAKE	0x80		/* for board_info; true iff can wake */
+#define I2C_CLIENT_SCCB	0x9000		/* Use Omnivision SCCB protocol */
+					/* Must match I2C_M_STOP|IGNORE_NAK */
 
 /* i2c adapter classes (bitmask) */
 #define I2C_CLASS_HWMON		(1<<0)	/* lm_sensors, ... */
@@ -541,6 +543,7 @@ struct i2c_msg {
 	__u16 flags;
 #define I2C_M_TEN		0x0010	/* this is a ten bit chip address */
 #define I2C_M_RD		0x0001	/* read data, from slave to master */
+#define I2C_M_STOP		0x8000	/* if I2C_FUNC_PROTOCOL_MANGLING */
 #define I2C_M_NOSTART		0x4000	/* if I2C_FUNC_NOSTART */
 #define I2C_M_REV_DIR_ADDR	0x2000	/* if I2C_FUNC_PROTOCOL_MANGLING */
 #define I2C_M_IGNORE_NAK	0x1000	/* if I2C_FUNC_PROTOCOL_MANGLING */