Commit d58f4f27 authored by Rémi Cardona's avatar Rémi Cardona Committed by Mauro Carvalho Chehab

[media] ds3000: bail out early on i2c failures during firmware load

- if kmalloc() returns NULL, we can return immediately without trying
   to kfree() a NULL pointer.
 - if i2c_transfer() fails, error out immediately instead of trying to
   upload the remaining bytes of the firmware.
 - the error code is then properly propagated down to ds3000_initfe().
Signed-off-by: default avatarRémi Cardona <remi.cardona@smartjog.com>
Reviewed-by: default avatarAntti Palosaari <crope@iki.fi>
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab@redhat.com>
parent 7e5d74ee
......@@ -272,15 +272,14 @@ static int ds3000_i2c_gate_ctrl(struct dvb_frontend *fe, int enable)
static int ds3000_writeFW(struct ds3000_state *state, int reg,
const u8 *data, u16 len)
{
int i, ret = -EREMOTEIO;
int i, ret = 0;
struct i2c_msg msg;
u8 *buf;
buf = kmalloc(33, GFP_KERNEL);
if (buf == NULL) {
printk(KERN_ERR "Unable to kmalloc\n");
ret = -ENOMEM;
goto error;
return -ENOMEM;
}
*(buf) = reg;
......@@ -300,8 +299,10 @@ static int ds3000_writeFW(struct ds3000_state *state, int reg,
printk(KERN_ERR "%s: write error(err == %i, "
"reg == 0x%02x\n", __func__, ret, reg);
ret = -EREMOTEIO;
goto error;
}
}
ret = 0;
error:
kfree(buf);
......@@ -384,6 +385,7 @@ static int ds3000_load_firmware(struct dvb_frontend *fe,
const struct firmware *fw)
{
struct ds3000_state *state = fe->demodulator_priv;
int ret = 0;
dprintk("%s\n", __func__);
dprintk("Firmware is %zu bytes (%02x %02x .. %02x %02x)\n",
......@@ -396,10 +398,10 @@ static int ds3000_load_firmware(struct dvb_frontend *fe,
/* Begin the firmware load process */
ds3000_writereg(state, 0xb2, 0x01);
/* write the entire firmware */
ds3000_writeFW(state, 0xb0, fw->data, fw->size);
ret = ds3000_writeFW(state, 0xb0, fw->data, fw->size);
ds3000_writereg(state, 0xb2, 0x00);
return 0;
return ret;
}
static int ds3000_set_voltage(struct dvb_frontend *fe, fe_sec_voltage_t voltage)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment