e1000e: fix ethtool autoneg off for non-copper

This patch fixes the issues for disabling auto-negotiation and forcing
speed and duplex settings for the non-copper media.

For non-copper media, e1000_get_settings should return ETH_TP_MDI_INVALID for
eth_tp_mdix_ctrl instead of ETH_TP_MDI_AUTO so subsequent e1000_set_settings
call would not fail with -EOPNOTSUPP.

e1000_set_spd_dplx should not automatically turn autoneg back on for forced
1000 Mbps full duplex settings for non-copper media.

Cc: xe-kernel@external.cisco.com
Cc: Daniel Walker <dwalker@fifo99.com>
Signed-off-by: Steve Shih <sshih@cisco.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/e1000e/ethtool.c

@@ -201,6 +201,9 @@ static int e1000_get_settings(struct net_device *netdev,
 	else
 		ecmd->eth_tp_mdix_ctrl = hw->phy.mdix;
 
+	if (hw->phy.media_type != e1000_media_type_copper)
+		ecmd->eth_tp_mdix_ctrl = ETH_TP_MDI_INVALID;
+
 	return 0;
 }
 
@@ -236,8 +239,13 @@ static int e1000_set_spd_dplx(struct e1000_adapter *adapter, u32 spd, u8 dplx)
 		mac->forced_speed_duplex = ADVERTISE_100_FULL;
 		break;
 	case SPEED_1000 + DUPLEX_FULL:
+		if (adapter->hw.phy.media_type == e1000_media_type_copper) {
 			mac->autoneg = 1;
-		adapter->hw.phy.autoneg_advertised = ADVERTISE_1000_FULL;
+			adapter->hw.phy.autoneg_advertised =
+				ADVERTISE_1000_FULL;
+		} else {
+			mac->forced_speed_duplex = ADVERTISE_1000_FULL;
+		}
 		break;
 	case SPEED_1000 + DUPLEX_HALF:	/* not supported */
 	default: