Merge branch 'merge' of git://git.kernel.org/pub/scm/linux/kernel/git/paulus/powerpc

* 'merge' of git://git.kernel.org/pub/scm/linux/kernel/git/paulus/powerpc:
  powerpc: Update desktop/server defconfigs
  powerpc: Fix msr check in compat_sys_swapcontext
  powerpc: Repair device bindings documentation
  powerpc: Updated Freescale PPC related defconfigs
  powerpc: Update QE/CPM2 usb_ctlr structures for USB support
  powerpc/86xx: Correct SOC bus-frequency in GE Fanuc SBC610 DTS
  powerpc: Fix Book-E watchdog timer interval setting
  powerpc/fsl-booke: Fix synchronization bug w/local tlb invalidates

Documentation/powerpc/booting-without-of.txt

@@ -41,25 +41,14 @@ Table of Contents
   VI - System-on-a-chip devices and nodes
     1) Defining child nodes of an SOC
     2) Representing devices without a current OF specification
-      a) MDIO IO device
-      b) Gianfar-compatible ethernet nodes
-      c) PHY nodes
-      d) Interrupt controllers
-      e) I2C
-      f) Freescale SOC USB controllers
-      g) Freescale SOC SEC Security Engines
-      h) Board Control and Status (BCSR)
-      i) Freescale QUICC Engine module (QE)
-      j) CFI or JEDEC memory-mapped NOR flash
-      k) Global Utilities Block
-      l) Freescale Communications Processor Module
-      m) Chipselect/Local Bus
-      n) 4xx/Axon EMAC ethernet nodes
-      o) Xilinx IP cores
-      p) Freescale Synchronous Serial Interface
-	  q) USB EHCI controllers
-      r) MDIO on GPIOs
-      s) SPI busses
+      a) PHY nodes
+      b) Interrupt controllers
+      c) CFI or JEDEC memory-mapped NOR flash
+      d) 4xx/Axon EMAC ethernet nodes
+      e) Xilinx IP cores
+      f) USB EHCI controllers
+      g) MDIO on GPIOs
+      h) SPI busses
 
   VII - Marvell Discovery mv64[345]6x System Controller chips
     1) The /system-controller node
@@ -1830,41 +1819,7 @@ platforms are moved over to use the flattened-device-tree model.
 		   big-endian;
 	   };
 
-    r) Freescale Display Interface Unit
-
-    The Freescale DIU is a LCD controller, with proper hardware, it can also
-    drive DVI monitors.
-
-    Required properties:
-    - compatible : should be "fsl-diu".
-    - reg : should contain at least address and length of the DIU register
-      set.
-    - Interrupts : one DIU interrupt should be describe here.
-
-    Example (MPC8610HPCD)
-	display@2c000 {
-		compatible = "fsl,diu";
-		reg = <0x2c000 100>;
-		interrupts = <72 2>;
-		interrupt-parent = <&mpic>;
-	};
-
-    s) Freescale on board FPGA
-
-    This is the memory-mapped registers for on board FPGA.
-
-    Required properities:
-    - compatible : should be "fsl,fpga-pixis".
-    - reg : should contain the address and the lenght of the FPPGA register
-      set.
-
-    Example (MPC8610HPCD)
-	board-control@e8000000 {
-		compatible = "fsl,fpga-pixis";
-		reg = <0xe8000000 32>;
-	};
-
-   r) MDIO on GPIOs
+   g) MDIO on GPIOs
 
    Currently defined compatibles:
    - virtual,gpio-mdio
@@ -1884,7 +1839,7 @@ platforms are moved over to use the flattened-device-tree model.
 			 &qe_pio_c 6>;
 	};
 
-    s) SPI (Serial Peripheral Interface) busses
+    h) SPI (Serial Peripheral Interface) busses
 
     SPI busses can be described with a node for the SPI master device
     and a set of child nodes for each SPI slave on the bus.  For this

arch/powerpc/boot/dts/gef_sbc610.dts

@@ -108,7 +108,7 @@ soc@fef00000 {
 		compatible = "simple-bus";
 		ranges = <0x0 0xfef00000 0x00100000>;
 		reg = <0xfef00000 0x100000>;	// CCSRBAR 1M
-		bus-frequency = <0>;
+		bus-frequency = <33333333>;
 
 		i2c1: i2c@3000 {
 			#address-cells = <1>;

arch/powerpc/include/asm/immap_cpm2.h

@@ -554,14 +554,11 @@ typedef struct usb_ctlr {
 	u8	usb_usadr;
 	u8	usb_uscom;
 	u8	res1[1];
-	u16	usb_usep1;
-	u16	usb_usep2;
-	u16	usb_usep3;
-	u16	usb_usep4;
+	__be16  usb_usep[4];
 	u8	res2[4];
-	u16	usb_usber;
+	__be16  usb_usber;
 	u8	res3[2];
-	u16	usb_usbmr;
+	__be16  usb_usbmr;
 	u8	usb_usbs;
 	u8	res4[7];
 } usb_cpm2_t;

arch/powerpc/include/asm/immap_qe.h

@@ -215,10 +215,7 @@ struct usb_ctlr {
 	u8	usb_usadr;
 	u8	usb_uscom;
 	u8	res1[1];
-	__be16	usb_usep1;
-	__be16	usb_usep2;
-	__be16	usb_usep3;
-	__be16	usb_usep4;
+	__be16  usb_usep[4];
 	u8	res2[4];
 	__be16	usb_usber;
 	u8	res3[2];

arch/powerpc/kernel/misc_32.S

@@ -470,6 +470,8 @@ _GLOBAL(_tlbil_pid)
 	mfspr	r3,SPRN_MMUCSR0
 	andi.	r3,r3,MMUCSR0_TLBFI@l
 	bne	1b
+	msync
+	isync
 	blr
 
 /*
@@ -486,6 +488,8 @@ _GLOBAL(_tlbil_va)
 	rlwinm	r4,r4,0,1,31
 	mtspr	SPRN_MAS1,r4
 	tlbwe
+	msync
+	isync
 	blr
 #endif /* CONFIG_FSL_BOOKE */
 

arch/powerpc/kernel/signal_32.c

@@ -941,9 +941,21 @@ long sys_swapcontext(struct ucontext __user *old_ctx,
 #ifdef CONFIG_PPC64
 	unsigned long new_msr = 0;
 
-	if (new_ctx &&
-	    get_user(new_msr, &new_ctx->uc_mcontext.mc_gregs[PT_MSR]))
+	if (new_ctx) {
+		struct mcontext __user *mcp;
+		u32 cmcp;
+
+		/*
+		 * Get pointer to the real mcontext.  No need for
+		 * access_ok since we are dealing with compat
+		 * pointers.
+		 */
+		if (__get_user(cmcp, &new_ctx->uc_regs))
+			return -EFAULT;
+		mcp = (struct mcontext __user *)(u64)cmcp;
+		if (__get_user(new_msr, &mcp->mc_gregs[PT_MSR]))
 			return -EFAULT;
+	}
 	/*
 	 * Check that the context is not smaller than the original
 	 * size (with VMX but without VSX)