pseries/iommu: Restore iommu table pointer when restoring iommu ops

When we swtich to direct dma ops, we set the dma data union to have the
dma offset.  When we switch back to iommu table ops because of a later
dma_set_mask, we need to restore the iommu table pointer. Without this
change, crashes have been observed on kexec where (for reasons still
being investigated) we fall back to a 32-bit dma mask on a particular
device and then panic because the table pointer is not valid.

The easiset way to find this value is to call
pci_dma_dev_setup_pSeriesLP which will search up the pci tree until it
finds the node with the table.
Signed-off-by: Nishanth Aravamudan <nacc@us.ibm.com>
Cc: Milton Miller <miltonm@bga.com>
Cc: Paul Mackerras <paulus@samba.org>
Cc: Anton Blanchard <anton@samba.org>
Cc: linuxppc-dev@lists.ozlabs.org
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>

arch/powerpc/platforms/pseries/iommu.c

@@ -1029,10 +1029,10 @@ static int dma_set_mask_pSeriesLP(struct device *dev, u64 dma_mask)
 	if (!dev->dma_mask || !dma_supported(dev, dma_mask))
 		return -EIO;
 
+	pdev = to_pci_dev(dev);
+
 	/* only attempt to use a new window if 64-bit DMA is requested */
 	if (!disable_ddw && dma_mask == DMA_BIT_MASK(64)) {
-		pdev = to_pci_dev(dev);
-
 		dn = pci_device_to_OF_node(pdev);
 		dev_dbg(dev, "node is %s\n", dn->full_name);
 
@@ -1063,6 +1063,7 @@ static int dma_set_mask_pSeriesLP(struct device *dev, u64 dma_mask)
 	if (!ddw_enabled) {
 		dev_info(dev, "Using 32-bit DMA via iommu\n");
 		set_dma_ops(dev, &dma_iommu_ops);
+		pci_dma_dev_setup_pSeriesLP(pdev);
 	}
 
 	*dev->dma_mask = dma_mask;