usb: dwc3: gadget: WARN on no-resource status

If the driver issued START_TRANSFER and received a no-resource status,
then generally there are a few reasons for this:

1) The driver did not allocate resource for the endpoint during
power-on-reset initialization.

2) The transfer resource was reset. At this moment, we don't do this in
the driver, but it occurs when the driver issues START_CONFIG cmd to ep0
with resource index=2.

3) The driver issues the START_TRANSFER command to an already started
endpoint. Usually, this is because the END_TRANSFER command hasn't
completed yet.

Print out a warning to help debug this issue in the driver.
Signed-off-by: Thinh Nguyen <thinhn@synopsys.com>
Signed-off-by: Felipe Balbi <balbi@kernel.org>

drivers/usb/dwc3/gadget.c

@@ -356,6 +356,8 @@ int dwc3_send_gadget_ep_cmd(struct dwc3_ep *dep, unsigned cmd,
 				ret = 0;
 				break;
 			case DEPEVT_TRANSFER_NO_RESOURCE:
+				dev_WARN(dwc->dev, "No resource for %s\n",
+					 dep->name);
 				ret = -EINVAL;
 				break;
 			case DEPEVT_TRANSFER_BUS_EXPIRY: