Commit f8b8a80f authored by David S. Miller's avatar David S. Miller
parents a32fd63d fb14ca43
......@@ -990,29 +990,16 @@ static int iwl_trans_tx_stop(struct iwl_trans *trans)
return 0;
}
static void iwl_trans_pcie_disable_sync_irq(struct iwl_trans *trans)
static void iwl_trans_pcie_stop_device(struct iwl_trans *trans)
{
unsigned long flags;
struct iwl_trans_pcie *trans_pcie =
IWL_TRANS_GET_PCIE_TRANS(trans);
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
/* tell the device to stop sending interrupts */
spin_lock_irqsave(&trans->shrd->lock, flags);
iwl_disable_interrupts(trans);
spin_unlock_irqrestore(&trans->shrd->lock, flags);
/* wait to make sure we flush pending tasklet*/
synchronize_irq(bus(trans)->irq);
tasklet_kill(&trans_pcie->irq_tasklet);
}
static void iwl_trans_pcie_stop_device(struct iwl_trans *trans)
{
/* stop and reset the on-board processor */
iwl_write32(bus(trans), CSR_RESET, CSR_RESET_REG_FLAG_NEVO_RESET);
/* tell the device to stop sending interrupts */
iwl_trans_pcie_disable_sync_irq(trans);
/* device going down, Stop using ICT table */
iwl_disable_ict(trans);
......@@ -1039,6 +1026,20 @@ static void iwl_trans_pcie_stop_device(struct iwl_trans *trans)
/* Stop the device, and put it in low power state */
iwl_apm_stop(priv(trans));
/* Upon stop, the APM issues an interrupt if HW RF kill is set.
* Clean again the interrupt here
*/
spin_lock_irqsave(&trans->shrd->lock, flags);
iwl_disable_interrupts(trans);
spin_unlock_irqrestore(&trans->shrd->lock, flags);
/* wait to make sure we flush pending tasklet*/
synchronize_irq(bus(trans)->irq);
tasklet_kill(&trans_pcie->irq_tasklet);
/* stop and reset the on-board processor */
iwl_write32(bus(trans), CSR_RESET, CSR_RESET_REG_FLAG_NEVO_RESET);
}
static int iwl_trans_pcie_tx(struct iwl_trans *trans, struct sk_buff *skb,
......
......@@ -634,7 +634,7 @@ static int lbs_ret_scan(struct lbs_private *priv, unsigned long dummy,
if (channel &&
!(channel->flags & IEEE80211_CHAN_DISABLED))
cfg80211_inform_bss(wiphy, channel,
bssid, le64_to_cpu(*(__le64 *)tsfdesc),
bssid, get_unaligned_le64(tsfdesc),
capa, intvl, ie, ielen,
LBS_SCAN_RSSI_TO_MBM(rssi),
GFP_KERNEL);
......
......@@ -819,8 +819,10 @@ mwifiex_scan_setup_scan_config(struct mwifiex_private *priv,
wildcard_ssid_tlv->header.len = cpu_to_le16(
(u16) (ssid_len + sizeof(wildcard_ssid_tlv->
max_ssid_length)));
wildcard_ssid_tlv->max_ssid_length =
user_scan_in->ssid_list[ssid_idx].max_len;
/* max_ssid_length = 0 tells firmware to perform
specific scan for the SSID filled */
wildcard_ssid_tlv->max_ssid_length = 0;
memcpy(wildcard_ssid_tlv->ssid,
user_scan_in->ssid_list[ssid_idx].ssid,
......
......@@ -2288,6 +2288,7 @@ void ieee80211_sta_quiesce(struct ieee80211_sub_if_data *sdata)
cancel_work_sync(&ifmgd->request_smps_work);
cancel_work_sync(&ifmgd->monitor_work);
cancel_work_sync(&ifmgd->beacon_connection_loss_work);
if (del_timer_sync(&ifmgd->timer))
set_bit(TMR_RUNNING_TIMER, &ifmgd->timers_running);
......@@ -2296,7 +2297,6 @@ void ieee80211_sta_quiesce(struct ieee80211_sub_if_data *sdata)
if (del_timer_sync(&ifmgd->chswitch_timer))
set_bit(TMR_RUNNING_CHANSW, &ifmgd->timers_running);
cancel_work_sync(&ifmgd->monitor_work);
/* these will just be re-established on connection */
del_timer_sync(&ifmgd->conn_mon_timer);
del_timer_sync(&ifmgd->bcn_mon_timer);
......
......@@ -141,8 +141,9 @@ ieee80211_add_rx_radiotap_header(struct ieee80211_local *local,
pos++;
/* IEEE80211_RADIOTAP_RATE */
if (status->flag & RX_FLAG_HT) {
if (!rate || status->flag & RX_FLAG_HT) {
/*
* Without rate information don't add it. If we have,
* MCS information is a separate field in radiotap,
* added below. The byte here is needed as padding
* for the channel though, so initialise it to 0.
......@@ -163,12 +164,14 @@ ieee80211_add_rx_radiotap_header(struct ieee80211_local *local,
else if (status->flag & RX_FLAG_HT)
put_unaligned_le16(IEEE80211_CHAN_DYN | IEEE80211_CHAN_2GHZ,
pos);
else if (rate->flags & IEEE80211_RATE_ERP_G)
else if (rate && rate->flags & IEEE80211_RATE_ERP_G)
put_unaligned_le16(IEEE80211_CHAN_OFDM | IEEE80211_CHAN_2GHZ,
pos);
else
else if (rate)
put_unaligned_le16(IEEE80211_CHAN_CCK | IEEE80211_CHAN_2GHZ,
pos);
else
put_unaligned_le16(IEEE80211_CHAN_2GHZ, pos);
pos += 2;
/* IEEE80211_RADIOTAP_DBM_ANTSIGNAL */
......
......@@ -881,6 +881,8 @@ struct sk_buff *ieee80211_build_probe_req(struct ieee80211_sub_if_data *sdata,
skb = ieee80211_probereq_get(&local->hw, &sdata->vif,
ssid, ssid_len,
buf, buf_len);
if (!skb)
goto out;
if (dst) {
mgmt = (struct ieee80211_mgmt *) skb->data;
......@@ -889,6 +891,8 @@ struct sk_buff *ieee80211_build_probe_req(struct ieee80211_sub_if_data *sdata,
}
IEEE80211_SKB_CB(skb)->flags |= IEEE80211_TX_INTFL_DONT_ENCRYPT;
out:
kfree(buf);
return skb;
......
......@@ -2265,6 +2265,9 @@ void /* __init_or_exit */ regulatory_exit(void)
kfree(last_request);
last_request = NULL;
dev_set_uevent_suppress(&reg_pdev->dev, true);
platform_device_unregister(reg_pdev);
spin_lock_bh(&reg_pending_beacons_lock);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment