Commit 0307d589 authored by Vincent Bernat's avatar Vincent Bernat Committed by David S. Miller

bonding: add documentation for peer_notif_delay

Ability to tweak the interval between peer notifications has been
added in 07a4ddec ("bonding: add an option to specify a delay
between peer notifications") but the documentation was not updated.
Signed-off-by: default avatarVincent Bernat <vincent@bernat.ch>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent fe4e8db0
......@@ -707,8 +707,8 @@ num_unsol_na
failover event. As soon as the link is up on the new slave
(possibly immediately) a peer notification is sent on the
bonding device and each VLAN sub-device. This is repeated at
each link monitor interval (arp_interval or miimon, whichever
is active) if the number is greater than 1.
the rate specified by peer_notif_delay if the number is
greater than 1.
The valid range is 0 - 255; the default value is 1. These options
affect only the active-backup mode. These options were added for
......@@ -727,6 +727,16 @@ packets_per_slave
The valid range is 0 - 65535; the default value is 1. This option
has effect only in balance-rr mode.
peer_notif_delay
Specify the delay, in milliseconds, between each peer
notification (gratuitous ARP and unsolicited IPv6 Neighbor
Advertisement) when they are issued after a failover event.
This delay should be a multiple of the link monitor interval
(arp_interval or miimon, whichever is active). The default
value is 0 which means to match the value of the link monitor
interval.
primary
A string (eth0, eth2, etc) specifying which slave is the
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment