Commit 052eb2d4 authored by Axel Lin's avatar Axel Lin Committed by Mark Brown

spi: core: Set max_speed_hz of spi_device default to max_speed_hz of controller

In __spi_validate(), xfer->speed_hz is set to be spi->max_speed_hz if it is not
set for this transfer. However, if spi->max_speed_hz is also not set,
xfer->speed_hz is 0. Some drivers (e.g. au1550, tegra114, tegra20-sflash,
tegra20-slink, etc.) then use below code to avoid setting xfer->speed_hz to 0.

        /* Set speed to the spi max fequency if spi device has not set */
        spi->max_speed_hz = spi->max_speed_hz ? : tspi->spi_max_frequency;

Let's handle it in spi core.
If spi->max_speed_hz is not set, make it default to spi->master->max_speed_hz.
So In __spi_validate() if both xfer->speed_hz and spi->max_speed_hz are not set,
xfer->speed_hz will be set to spi->master->max_speed_hz.
Signed-off-by: default avatarAxel Lin <axel.lin@ingics.com>
Signed-off-by: default avatarMark Brown <broonie@linaro.org>
parent 38dbfb59
...@@ -1599,6 +1599,9 @@ int spi_setup(struct spi_device *spi) ...@@ -1599,6 +1599,9 @@ int spi_setup(struct spi_device *spi)
if (!spi->bits_per_word) if (!spi->bits_per_word)
spi->bits_per_word = 8; spi->bits_per_word = 8;
if (!spi->max_speed_hz)
spi->max_speed_hz = spi->master->max_speed_hz;
if (spi->master->setup) if (spi->master->setup)
status = spi->master->setup(spi); status = spi->master->setup(spi);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment